Viper d1200.1, d600.1 SPECIFICATIONS d600.1/d1200.1, Viper model d600.1 d1200.1

RMS continuous power driven into 4 ohms from 20 to 250 Hz @ 14.4 VDC at rated power/load.

RMS continuous power driven into 2 ohms from 20 to 250 Hz @ 14.4 VDC at rated power/load.

RMS continuous power driven into 1 ohm from 20 to 250 Hz @ 14.4 VDC at rated power/load.

Dynamic power rating (IHF-202 Standard) minimum load.

RMS continuous power driven into 4 ohms from 20 to 250 Hz @ 14.4 VDC in synced bridge mode (bridged pairs).

RMS continuous power driven into 2 ohms from 20 to 250 Hz @ 14.4 VDC in synced bridge mode (bridged pairs).

Signal-to-Noise Ratio

Frequency Response

Damping Factor

Crossover

Subsonic Filter

Bass Equalization

Input Impedance

Input Sensitivity

Output Impedance Supply Voltage Fusing and Power

Minimum Cable Requirements (AWG) (Per amp, trunk mounted)

275450

watts watts

0.4% THD 0.5%

400800

watts watts

0.6% THD 0.7%

6001200

watts watts

0.8% THD 0.9%

7501500

watts watts

8001600

watts watts

1200 2400

watts watts

Greater than 80 dB

20-250 Hz +0, -1 dB

50 (typical)

Low-pass 24 dB/octave, variable from 30 to 250 Hz

Switchable 24 dB/ octave, variable from 20 to 250 Hz

Variable 0 to +12 dB, centered at 40Hz

20K ohms

Variable from 150 mV to 8 volt

1 to 4 ohms

10 to 16 VDC

60A 90A

#8 #4