R2200 Assembly
Step 5 • Pedals
1:Identify the left and right Pedals (152) and the left and right Pedal Straps (199). Attach the correct straps to each pedal, then thread each Pedal into the correct left and right crank arms and tighten.
NOTE: It is very important to FULLY TIGHTEN each pedal. Failure to do so will result in loosening and NOISE.
Step 6 • Console Mast
1:Unfold the Console Cable (75) that is folded into the Frame Console Mast bracket. Straighten this cable and remove any kinks by drawing the cable through your fingers. Find the string that is attached to the inside of the Console Mast (101), but do not remove yet.
2:Slide the Rubber Console Mast Cover (88) onto the Console Mast (101) until it is above the first waterbottle screw.
3:Now attach the Console Cable (75) to the string located inside the Console Mast. Holding the Console Mast (101) above the Frame Console Mast Bracket, guide the Console Cable (75) through the Console Mast while simultaneously sliding the Console Mast onto the frame bracket.
4:Bolt the Console Mast (101) to the frame using the six Console Mast Allen bolts (182). Make sure these bolts are very tight. Now slide the Rubber Console Mast Cover (88) back down to cover the bolt heads.
