Vision Fitness R2650HRT manual S T E P 1 ORANGE BAG, Blue Bag, Rear Foot

S T E P 1

S T E P 1 ORANGE BAG

•Install the rear foot with the four lock washers (M8), two inside screws (M8x65L), and two outside screws (M8x20L). Tighten with the 5mm T-Shaped wrench.

S T E P 2 BLUE BAG

Rear Foot

S T E P 2

Console Mast

Console Mast

Boot

Frame

Bracket

•Slide the console mast boot onto the console mast.

•Unfold the wire harness and heart rate wires located in the console mast frame bracket. Attach the wire tie coming from the bottom of the console mast to the wire harness and heart rate wires. Pull the wire tie with wire harness and heart rate wires up through the top of the console mast while simultaneously sliding the mast into the frame bracket.

•Secure the console mast to the frame bracket with six screws (M8x15L). Tighten with the 5mm T-Shaped wrench. Insert a set screw (M10 x 12L) to the front edge of the mast and tighten until snug with the 5mm T-shaped wrench.

•Slide the console mast boot down and snap it into place on the side cover.

5