Vita-Mix 120 VAC Models ustom Programming

The Touch and GoTMBlending Station®advanced electronic control can be

custom programmed, requiring an optional programming chip, available

from Vita-Mix for a nominal fee and with a minimum unit purchase. Contact

your Vita-Mix representative for more information .

1. Insert the custom programmed chip with the

words, “THIS SIDE FACING TO THE FRONT

OF THE MACHINE” toward you, into the port

located below the label area on the front of the

Blending Station. The DISPLAYWINDOW will

read ‘New Module’.

2. Within 10 seconds the SIX PRE-SET buttons will be re-programmed and

the DISPLAYWINDOW will read ‘Saved’ then ‘Ready’. If nothing happens

when the programming chip is fully inserted, turn the chip in the opposite

direction and try again.

3. Remove the programming chip and return it to the original package.

4. Press one of the six PRE-SET buttons to reveal, in the DISPLAYWINDOW,

the name of the program/drink.

NOTE: If for any reason the programmed times are incorrect, they can be

reset to the original factory settings following the instructions on page 7.

1. Remove the container from the machine.

2. Lift the machine from the bottom edges to reveal the motor and housing

area. With the machine facing towards you, locate the slot underneath on

the right hand side of the machine between the motor and the outer wall.

3. Insert the custom programmed chip into the slot with the words, “THIS

SIDE FACING TO THE FRONT OF THE MACHINE” turned facing out to

the right of the machine. Once inserted the DISPLAYWINDOW will read

‘New Module’.

ustom Programming

Custom

Programmed

Chip