VIVOTEK - A Leading Provider of Multimedia Communication Solutions
Appendix
A. Troubleshooting
Status LED
The following table lists the LED patterns in general.
| Condition | LED color | |
|
|
| |
| LoStatusdingLEDsystemColorafter power on | DescriptionSteady green and blink red (once) |
|
|
|
|
|
| Blinking red | Power is being supplied to the camera. | |
| Solid green | The camera is booting up. | |
| Solid green with blinking red in between | The camera is trying to obtain an IP address. | |
| Solid green and red | An IP address is successfully assigned to the camera. | |
| Solid red with blinking green in between | The camera is working. | |
| Blinking red and green | During firmware upgrading | |
|
|
|
|
Reset and restore
There is a button in the back of the Network Camera. It is used to reset the system or restore the factory default settings. Sometimes resetting the system sets the system back to normal state. If the system problems remain after reset, restore the factory settings and install again.
RESET: Click on the button. 
RESTORE:
- 50 -
www.vivotek.com
User's Manual - 50
