Vivotek ip7135 Troubleshooting, URL commands of the Network Camera, Status LED, Reset and restore

Restoring the factory defaults

will erase any previous settings. Reset or restore the system after power on.

VIVOTEK - A Leading Provider of Multimedia Communication Solutions

Appendix

A. Troubleshooting

Status LED

The following table lists the LED patterns in general.

Condition	LED color
Loading system after power on	Steady blue
During booting procedure	Steady blue and red
Detecting and setting network	Steady blue and blink red till IP address is
	confirmed
After network is setup (system up)	Blink blue every second and steady red
During the upgrade firmware process	Blink blue every second and fast blink red

Reset and restore

There is a button in the back of the Network Camera. It is used to reset the system or restore the factory default settings. Sometimes resetting the system sets the system back to normal state. If the system problems remain after reset, restore the factory settings and install again.

RESET: Click on the button.

RESTORE: 1. Press on the button continuously. 2. Wait for self-diagnostic to run twice.

3. Free the button as soon as the second self-diagnostic starts.

B. URL commands of the Network Camera

For some customers who already have their own web site or web control application, the Network Camera can be easily integrated through convenient URLs. This section

42 - User's Manual