VIKING MEMORY
INSTALLATION GUIDE
SONY®
VAIO PCG-808, PCG-812, PCG-818
Manual No. 1005206 • Release 04/99, Rev. D
S P E E D • P O W E R • P E R F O R M A N C E ®
The Sony VAIO
Description | Viking P/N |
32MB SDRAM Memory Module | SNY732, RSNY732 |
64MB SDRAM Memory Module | SNY764, RSNY764 |
128MB SDRAM Memory Module | SNY7128, RSNY7128 |
*Requires the removal of all standard memory.
Caution:
Electro Static Discharge (ESD) can damage electronic components. Before touching the mem- ory module,ensure that you are discharged of static electricity by touching a grounded metal object.
INSTALLATION INSTRUCTIONS:
1.Turn the computer off and disconnect the AC power supply and any other cables from the unit.
Note: If the unit appears to be powered down, ensure that it is not in Suspend mode.
2.Turn the computer
3.Locate the memory expansion cover on the right side of the bottom panel. Also locate the two holding screws securing this cover to the bottom panel. Remove the screws with a small Phillips screwdriver. Then remove cover by lifting it toward you.
4.Locate the single memory expansion slot in the open compartment. Notice the loca- tion of the
5. To install a memory module, insert the module into the expansion slot at an angle and then push it down until it clicks into place. To be certain that the module is installed correctly, ensure that the off- center notch on the module is aligned with the
6.Replace the memory expansion cover and be sure to secure its two holding screws.
7.Replace the battery back into its compartment and turn the system
8.Replace the AC power supply and any other cables you may have disconnected.
9.Open the display screen and turn the system on. The computer will automatically reconfigure itself to recognize the newly added memory. The new memory can be veri- fied during the POST routine at
The installation is now complete.
WARRANTY & DISCLAIMERS:
All Viking Components products have been thoroughly tested free of defects in material and workman- ship. If any malfunction should occur while using one of our products in its recommended environment, Viking,at its option,will repair or replace the product at no charge,provided the product or any part there- of has not been abused, misused, neglected, replaced, repaired or modified. Viking shall make the final determination as to the existence and the cause of any defect. Viking will not repair or replace products designated as having a“Limited Lifetime”which fail solely because their estimated life has expired. No war- ranty is made with respect to customer products produced to original purchaser specifications except as specifically stated in writing by Viking.
All shipping costs shall be the responsibility of the purchaser.
Except as provided herein,there are no express or implied warranties of merchantability or fitness for a par- ticular purpose. Under no circumstances will Viking Components be liable in any way to the purchaser for any damages, including but not limited to lost revenue, lost wages, or any other incidental or consequen- tial damages arising out of the use of or inability to use this product. Viking reserves the right to make modifications in both hardware and software without prior notifications.
All Viking Components are 100% guaranteed compatible with the OEM machines for which they are designed. All OEM's names,trademarks and part numbers are used for identification purposes only,and in no way imply that any of our products are original equipment parts.
Sony and VAIO are a registered trademarks of Sony Electronics Inc.
Product names mentioned herein may be trademarks or registered trademarks of their respective compa- nies.
Copyright 1999 Viking Components, Inc.