VIZIO® VW32L HDTV40A User Manual
4.2 TV and Stand Base Assembly
If the original instructions had been misplaced or lost, the following steps are a duplicate of such document, removing the Stand Base may be the only steps to be done at this point.
NOTE: It is strongly recommended that two people perform the setup and assembly due to the weight and size of the TV.
To unpack the TV and stand base |
|
The following steps are required to assemble the two parts: | Stand Neck |
1.Remove the remote control, batteries, and power cord from the foam end caps.
2.Remove the two top foam end caps.
3.Remove the stand base under foam end cap.
4.Remove the TV from the box and lay it face down on a clean, flat surface.
Note: Make sure that the surface is free of debris to prevent the TV screen from getting scratched.
Stand Base
To attach the TV stand base:
1.Line up the arrows on the stand neck (attached to the TV) with the arrows on the stand base.
2.Push the stand base onto the stand neck until you hear them click together.
3.On the bottom of the base, insert the four included screws and tighten them up.
4.Move the TV into an upright position.
To remove the stand base
1.Remove the four screws from the stand base.
2.Pull the stand base away from the stand neck.
Version 10/17/2008 | 65 |
| www.VIZIO.com |
