VocoPro PV-802 manual Mounting on a Speaker Stand / Voltage Selector

Mounting on a Speaker Stand / Voltage Selector

Setting up the Speaker Stands

Setup each SS-88 speaker stand by extending the support lefts to a position that is stable and tighten the tension mechanism firmly.

Each end of the SS-88 pole has a particular diameter fitted for common speakers’ mounting cavities. If the SS-88 pole does NOT fit flush into the mounting adapter on the PV-802, loosen the SS-88 pole and reverse it in the stand and then remount the speaker.

Mounting the Speaker(s)

Once the adapter is securely attached to the speaker:

1. Place the PV-802 on the SS-88 speaker pole

2.Fasten the fastener on the adapter until it is secured tightly

3.Repeat this for the next speaker

Switching Voltage

The PV-802 has a voltage selector on the rear panel that switches between two voltage settings:

115V - North America, Canada, some South America

220V - Europe, Asia, some South America

Note: The PV-802 comes preset to 115V and will only need to be switched if it is being used in a region that requires 220V.

To switch the voltage

1.Locate the voltage selector by removing the VOLTAGE SELECT sticker on the rear panel of the powered PV-802 speaker

2.Switch the selector to the proper voltage

CAUTION: Using the speakers while set to the wrong voltage can result in permanent damage and will void the warranty. Make sure you have set the PV-802 to the correct voltage before using.

�������	�������
	��������

��������������

2www.vocopro.com