Vornado Whole Room Heater manual How To Use

How To Use

Getting Started

Using your Vornado Heater is easy. Just follow these simple steps.

1.Position your heater so the vortex beam of warm air is directed across the room unobstructed. Position it in a location that is representative of the room temperature. The unique side-angled air inlets allow the heater to be placed closer to walls than possible with most ordinary heaters (but do not place close to combustibles). Avoid areas of temperature extremes such as cold drafts and heat registers (refer to IMPORTANT INSTRUCTIONS for safe placement).

2.Plug power cord into a standard wall outlet.

3.Press the Power switch On.

4.Select Low, Medium or High heat.

5.Set thermostat to the highest setting. When the room reaches

the desired comfort level, turn the thermostat knob slowly counterclockwise until the heat cycles off.

Resetting Your Vornado Heater

Your Vornado Heater has a multi-level safety shut-off system designed to prevent overheating. Overheating may occur when the inlets or outlet are blocked, a foreign object prevents the blade from turning, or the appliance tips over. If this happens, the safety shut-off system will cut power to the heat element and you will need to manually reset the heater.

1.Turn the Power switch Off and unplug the unit.

2.Remove any obstructions.

3.Wait 5 –10 minutes, allowing the unit to cool down.

4.Plug in the unit and place in desired position.

5.Turn the Power switch On. Your Vornado Heater should now function normally.

Note: If the safety shut-off system repeatedly shuts off your heater or if it will not reset after following the above procedure, DO NOT ATTEMPT TO DISASSEMBLE THE UNIT. Call Vornado Consumer Services Department toll-free at 1-800-234-0604.

8English