Vox TB35C1, TB35C2 Speci cation

16 OHMS: Combos allow for the following co nﬁ gurations;

Set it to this if you use the internal speakers only.•

Set it to this if you connect an external 16 Ohm speaker cabinet through the External jack.•

8 OHMS: Combos allow for the following conﬁ gurations;

Set it to this if you connect an extension cabinet through the Extension jack. You’ll be run-•

ning the internal and external speakers in parallel. The impedance of the extension cabinet

must be 16 Ohms.

Set it to this if you connect an external 8 ohm speaker cabinet through the External jack.•

This is where you connect the included (VFS1) footswitch so you can

switch in and out of ‘macho’ mode.

This is where the supplied, detachable Mains (power) cord is con-

nected.

NOTE! Use only the power cable that is included with the TB35C1/

TB35C2. Using another power cable may cause malfunctions.

The speciﬁ c mains input voltage rating that your ampliﬁ er needs to run at is located on the rear

panel of your ampliﬁ er. Before making any connections or powering up the ampliﬁ er, make sure

the correct voltage is set. If you have any doubt, refer to your local VOX dealer.

Speciﬁ cation

TB35C1 TB35C2

Controls Volume (preamp), Bass, Mid, Treble, Reverb, Master volume, Bass

Boost, Macho (footswitchable), Master Volume Bypass

I/O Guitar Input High and Low, External speaker out, Extension speaker out,

Footswitch input

Tube Complement 4 x ECC83/12AX7, 1 x 12AT7, 4 x 6V6

Output Power 35Watts RMS

Speaker(s) 1 x 12” 16ohm Celestion G12-65 2 x 12” 8ohm Celestion G12-65

Dimensions (W x D x H) 600 x 260 x 565 mm

23.62 x 10.24 x 22.24 inches

695 x 260 x 565 mm

27.36 x 10.24 x 22.24 inches

Weight 28.8 kg / 63.49 lbs. 33.5 kg / 73.85 lbs.

Accessory Power cable, Footswitch (VFS1), Owner’s manual, Dust cover

Speciﬁ cations and appearance are subject to change without notice for improvement.