![](/images/new-backgrounds/1257325/2573255x1.webp)
socket. Place the battery pack into the compartment with the wires in one of the lower corners, along the bottom of the battery pack.
3. Replace the battery cover by sliding
it upwards.
4. If the new battery pack is not already charged, place the handset in the base unit, or a remote charging stand,
and allow it to charge for 12 hours.
After the first charge, a drained Handset battery pack will recharge in approximately 8 hours.
The original Handset that is shipped with your v 2651 or v 2656 will be automatically registered to the Base. This Handset is HANDSET 1.
As you register additional Handsets to the system, they will be assigned extension numbers in the following order: HANDSET 2 , HANDSET 3 , HANDSET 4 .
Whenever a Handset battery pack is installed, the Handset will automatically begin SEARCHING FOR BASE (if previously registered), or it will prompt you to ENTER BASE ID to register the new Handset.
BEFORE USING YOUR HANDSET(S), CAREFULLY PEEL OFF THE PROTECTIVE FILM, COVERING THE DISPLAY.
5
Getting Started | Setup |
|
|
Registration And Operation Of The VTECH v 2600
Accessory Handset
Your v 2651 or v 2656 system can support up to 4 Handsets.
The accessory Handset v 2600 consists of the following:
Setup Of The v 2600
Accessory Handset
1. Plug the AC power adapter into an electrical outlet.
2. Install the battery pack, as described on the following page.
Installation of Battery Pack in Handset
Follow the steps below:
1. Remove the battery cover by pressing on the indent and sliding downward.
2. Align the two holes in plug with the socket pins. Insert the plug into
4