WARRANTY STATEMENT
WHAT DOES OUR WARRANTY COVER?
* Any defect in material or workmanship.
FOR HOW LONG AFTER THE ORIGINAL PURCHASE?
* One Year.
WHAT WILL VTECH DO?
* At our option, repair or replace your unit.
HOW DO I SEND MY UNIT, IN OR OUT OF WARRANTY?
*Call VTECH Communications customer service for Return Authorization at:
*Properly pack your unit. Include any cables & accessories which were originally provided with the product. We recommend using the original carton and packing materials.
*Include in the package a copy of the sales receipt or other evidence of date of original purchase (if the unit was purchased within the last twelve months.)
*Print your name and address, along with a description of the defect, and include this in the package.
*Include payment for any service or repair not covered by the warranty, as determined by VTECH Communications.
*In the US, ship the unit via UPS Insured, or equivalent to:
VTECH COMMUNICATIONS 8770 SW NIMBUS AVENUE BEAVERTON, OREGON 97008
VTECH Communications assumes no responsibility for units sent without prior Return Authorization.
WHAT DOES OUR WARRANTY NOT COVER?
*Batteries
*Damage from misuse, neglect, or acts of nature (lightning, floods, power surges. etc.)
*Products which may have been modified or incorporated into other products
*Products purchased outside the USA
*Products serviced by the owner or a service facility not expressly authorized by VTECH Communications
*Products purchased more than 12 months from current date
HOW DOES STATE LAW RELATE TO THIS WARRANTY?
*This warranty gives you specific rights. You may also have other rights which vary from state to state.
IF YOU PURCHASED YOUR TELEPHONE IN CANADA
Please call:
Ship to: VTECH ELECTRONICS
RICHMOND, BC V6X 1Z9
12
MAINTENANCE
TAKING CARE OFYOUR TELEPHONE
Your VT 9108/VT 9105 cordless telephone contains sophisticated electronic parts so it must be treated with care.
Avoid rough treatment
Place the handset down gently. Save the original packing materials to protect your telephone if you ever need to ship it.
Avoid Water
Your telephone can be damaged if it gets wet. Do not use the handset outdoors in the rain, or handle it with wet hands. Do not install your base unit near a sink, bathtub or shower.
Remember that electrical appliances can cause serious injury if used when you are wet or standing in water. If your base unit should fall into water, DO NOT
RETRIEVE IT UNTIL YOU UNPLUG THE POWER CORD AND TELEPHONE LINE CORDS FROM THE WALL. Then pull the unit out by the unplugged cords.
Electrical Storms
Electrical storms can sometimes cause power surges harmful to electronic equipment.
For your own safety, use caution when using electric appliances during storms.
Cleaning your telephone
Your telephone has a durable plastic casing that should retain its luster for many years. Clean it only with a soft cloth slightly dampened with water or a mild soap. Do not use excess water or cleaning solvents of any kind.
TECHNICAL
SPECIFICATIONS
FREQUENCY CONTROL
Crystal Controlled Dual PLL Synthesizer
TRANSMIT FREQUENCY
Handset: 925.05 MHz to 927.75 MHz
Base: 902.3 MHz to 905.0 MHz
RECEIVE FREQUENCY Handset: 902.3 MHz to 905.0 MHz
Base: | 925.05 MHz to 927.75 MHz |
NOMINAL EFFECTIVE RANGE
Maximum power allowed by FCC and IC. Actual operating range may vary according to environmental conditions at the time of use.
SIZE
Handset: 17.5cm x 5.5cm x 3.9cm (L x W xT) maximum (antenna excluded)
Base: 19.3cm x 14.8cm x 5.4cm (L x W x T) maximum (antenna excluded)
WEIGHT
Handset: 166 grams
Base: 321 grams
POWER REQUIREMENTS
Handset:
Power Adapter: 9V DC @ 200mA
SPECIFICATIONS ARE TYPICAL AND MAY CHANGE WITHOUT NOTICE.
13
FCC AND IC REGULATIONS
FCC AND IC REGULATIONS
FCC AND IC REGULATIONS
This equipment complies with Parts 15 and 68 of the Federal Communications Commission (FCC) rules for the United States. It also complies with regulations
A label is located on the underside of the base unit containing either the FCC registration number and Ringer Equivalence Number (REN) or the IC registration number and Load Number. You must, upon request, provide this information to your local telephone company.
This equipment is compatible with inductively coupled hearing aids.
FCC Part 15
Warning:Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
The equipment has been tested and found to comply with part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:
*Reorient or relocate the receiving antenna.
*Increase the separation between the equipment and receiver.
*Connect the equipment into an outlet or on a circuit different from that to which the receiver is connected.
*Consult the dealer or an experienced radio/ TV technician for help.
FCC Part 68
The FCC requires that you connect your cordless telephone to the nationwide telephone network through a modular telephone jack (USOC RJ11C or RJ11W).
Your telephone company may discontinue your service if your equipment causes harm to the telephone network. They will notify you in advance of disconnection, if possible. During notification, you will be informed of your right to file a complaint with the FCC.
If it is determined that your telephone equipment is malfunctioning, the FCC requires that it not be used and that it be unplugged from the modular jack until the problem has been corrected. Repairs to this telephone equipment can only be made by the manufacturer or its authorized agents or by others who may be authorized by the FCC. For repair procedures, follow the instructions outlined under the VTECH Limited Warranty.
The REN is useful in determining the number of devices you may connect to your telephone line and still enable the devices to ring when you receive a call. The general rule is that the REN value should not exceed 5.0 total; however, contact your local telephone company for the specific number in your area.
IC (Industry Canada)
This telephone is registered for use in Canada.
Notice:The Industry Canada label identifies certified equipment.This certification means that the equipment meets certain telecommunications network, protective, operational and safety requirements. Industry Canada does not guarantee the equipment will operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local
telecommunications company.The equipment must also be installed using an acceptable method of connections. The customer should be aware that compliance with the above conditions may not prevent degradation of service in situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment
malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic water pipe system, if present, are connected together.
This precaution may be particularly important in rural areas.
Caution: Users should not attempt to make such connections themselves, but should contact appropriate electric inspection authority, or electrician, as appropriate.
Notice: The REN assigned to this device denotes the number of devices you may connect to the telephone loop,whice is used by the device to prevent verloading. The termination on a loop may consist of any combination devices subjected only to the requirement that the sum of the REN does not exceed five.(5.0)
This device complies with
14
15
