Quick start guide
for models
Install the telephone base and charger(s)
Install the telephone base and charger(s) as shown below.
Telephone |
|
|
wall jack | Telephone base | Charger |
DSL filter (not | power adapter | adapter |
included) required | (large) | (small) |
if you have DSL |
|
|
|
| |
Internet service |
|
|
Telephone line cord | Electrical outlet | |
not controlled | ||
| ||
| by a wall switch |
Battery installation and charging
Install the battery as shown below. After installing the battery, you might be able to make and receive short calls. For best performance, charge the handset battery for at least 16 hours before use.
1 | 2 |
If the battery | Plug the battery securely |
compartment cover is on | into the plug inside |
the handset, press the | the handset battery |
indentation and slide the | compartment, matching |
cover to remove. | the |
3 | 4 |
Place the battery with | Align the cover flat |
the label THIS SIDE | against the battery |
UP facing up and the | compartment, then slide |
wires inside the battery | it upwards until it clicks |
compartment. | into place. |
Make, answer and end a call
Make a call
1.Press /FLASH or .
2.Dial the number.
1.Dial the number.
2.Press /FLASH or .
Answer a call
•Press /FLASH, or any of the dialing keys
End a call
•Press OFF/CLEAR or put the handset in the telephone base or charger.
Activate the answering system
The answering system must be turned on to answer and record messages. Press ANS ON/OFF to turn the answering system on or off. When the answering system is turned on, it will announce “Calls will be answered,” and the ANS ON/OFF light will be on. When the answering system is turned off, it will announce “Calls will not be answered,”
Outgoing announcement
The telephone is preset with a greeting that answers calls with “Hello, please leave a message after the tone.” You can use this preset announcement, or replace it with your own.
To record your own announcement:
1.Press ANNC while the telephone is not in use and the system will announce “Announcement. Press PLAY or press RECORD.”
2.Press RECORD and the system announces, “Record after the tone. Press STOP when you are done.”
3.After the tone, speak towards the microphone at the bottom front of the telephone base from about nine inches away.
4.Press /PLAY/STOP when finished.
5.The answering system will automatically play the newly recorded announcement. Press /PLAY/STOP to stop the playback at anytime.
To play messages:
• Press /PLAY/STOP to play messages |
and stop playback. |
• Press X/DELETE while a message is |
playing to delete it. |
• Press /SKIP to skip to the next |
message. |
• Press /REPEAT to repeat the current |
message. |
Charger
Telephone base
NOTES:
1.Use only the power adapter(s) and battery(ies) supplied with your VTech telephone.
2.For complete feature instructions, please refer to your user’s manual.
5
Charge the handset by | CHARGE light |
placing it in the telephone |
|
base or charger. The |
|
CHARGE light will be |
|
on when the handset is |
|
charging. |
|
and the ANS ON/OFF light will be off.
• Press VOL / to raise or lower playback |
volume. |
IMPORTANT!
If your product is not working properly:
•Refer to the Troubleshooting section of the user’s manual.
•Visit our website at www.vtechphones. com or call 1 (800)