Quick start guide

Battery installation and charging

Install the battery as shown below. After
installing the battery, you may be able to make
and receive short calls. For best performance,
charge the handset battery for at least 16 hours
before use.

Make, answer and end a call

Make a call

Press /FLASH or .
You hear a dial tone.
Dial the number.

Make a predial call

Dial the number.
Press /FLASH or .

Answer a call

Press /FLASH, or any of the dialing keys
(0-9, #, TONE ).

End a call

Press OFF/CLEAR or put the handset in the
telephone base or charger.
1.
2.
1.
2.

for models LS6325/LS6325-2/LS6325-3/

LS6325-4/LS6325-5/LS6326-5

Install the telephone base and

charger(s)

Install the telephone base and charger(s) as
shown below.
Use only the power adapters and batteries
supplied with your VTech telephone.
For complete feature instructions, pleas e
refer to your user’s manual.
•
•
Telephone base
Telephone
line cord
Telephone
base power
adapter
Telephone
wall jack
If you have
DSL high
speed
Internet
service, a
DSL filter (not
included) is
required.
Charger
adapter
Charger
12
34
Plug the battery
connector securely
into the socket inside
the handset battery
compartment, matching
the color-coded label.
Place the battery with
the label THIS SIDE UP
facing up and the wires
inside the battery
compartment.
Align the cover at
against the battery
compartment, then slide
it towards the center of
the handset until it clicks
into place.
Charge the handset by
placing it in the telephone
base or charger. The
CHARGE light is on when
the handset charges.
If the battery
compartment cover is on
the handset, press on the
indentation and slide the
cover to remove.
5
Electrical
outlet not
controlled by
a wall switch
CHARGE
light

Push to talk (PTT)

You can directly broadcast messages from one
handset to the speakerphone of one or all other
handsets. Any handset you call can respond by
pressing PUSH TO TALK to begin a two-way
communication.
When the connection is made, both the caller
and the destination handsets display Press
and hold [PTT] to talk and beep once.
Only one handset can be talk at a time. To do
so, press and hold PUSH TO TALK.
For complete PTT instructions, pl ease refer
to your user’s manual.