HEADSET OPERATION
IN CASE OF DIFFICULTY
Your VT 1711 cordless telephone is | The headband can be adjusted to fit the | |
equipped with a 2.5mm Headset Jack for | contour of your head. Using both hands, | |
use with an optional accessory Headset | slide the headband up or down so that it | |
for | rests comfortably on your head, with the | |
|
| speaker cushion centered against your ear. |
If you choose to use the Headset option, |
| |
you must obtain an optional accessory | For maximum sound quality, the flexible | |
Headset, which is compatible with the VT | microphone should be positioned at the | |
1711. |
| corner of your mouth, about one inch from |
|
| your face. |
To purchase a Headset, call |
| |
VTech Customer Service at 1- | BELT CLIP | |
| The VT 1711 is also equipped with a | |
|
| |
Once you have a compatible 2.5mm | detachable belt clip. Align the pins on the | |
Headset, locate the Headset Jack on the | inside edge of the clip with the notches on | |
VT 1711 Handset. Connect the plug on the | the sides of the VT 1711 Handset. The belt | |
Headset cord to the jack on the cordless | clip should snap securely into place. Do not | |
Handset. The plug should fit securely. Do | force the connection. | |
not force the connection. |
| |
|
|
|
OPERATION |
| |
NOTE: Whenever a compatible Headset |
| |
is connected to the cordless Handset, the |
| |
microphone on the Handset will be muted. |
| |
This is done to limit the effect of background |
| |
noise. |
| |
The following operational characteristics |
| |
apply to VTech Headsets. The same may |
| |
also apply to other, |
| |
headsets, but VTech assumes no |
| |
responsibility for their performance. |
| |
The VTech brand compatible Headset has |
| |
a reversible, monaural design. You can wear |
| |
your Headset on either ear, leaving one ear |
| |
free for room conversation. |
| |
If you have difficulty operating your phone, the suggestions below should solve the problem. If you still have difficulty after trying these suggestions call VTECH Communications at
THE PHONE DOESN’T WORK AT ALL.
*Make sure the power cord is plugged in.
*Make sure the telephone line cord is plugged firmly into the base unit and the telephone wall jack.
*Make sure the batteries are properly charged. If the LOW BATT LED is flashing, the battery pack needs charging.
NO DIAL TONE
First check all the suggestions above. If you still don’t hear a dial tone, disconnect the base unit from the telephone jack and connect a different phone. If there is no dial tone on that phone either, the problem is in your wiring or local service. Call your local telephone company.
YOU GET NOISE, STATIC, OR A WEAK SIGNAL EVEN WHEN YOU’RE NEAR THE BASE UNIT.
Household appliances plugged into the same circuit as the base unit can some- times cause interference. Try moving the appliance or the base unit to another outlet.
YOU GET NOISE, STATIC, OR A WEAK SIGNAL WHEN YOU’RE AWAY FROM THE BASE UNIT.
*You may be out of range. Either move close to the base, or relocate the base unit.
*The layout of your home may be limiting the range. Try moving the base unit to another position.
THEHANDSETDOESNOTRINGWHEN
YOURECEIVEACALL.
*Make sure the telephone line cord is plugged firmly into the base unit and the telephone jack. Make sure the power cord is plugged in.
*You may be too far from the base unit.
*You may have too many extension phones on your telephone line to allow all of them to ring. Try unplugging some of the other phones.
YOU HEAR OTHER CALLS WHILE
USING YOUR PHONE.
Disconnect your base unit from the telephone jack, and plug in a regular telephone. If you still hear other calls, the problem is probably in your wiring or local service. Call your local telephone company.
YOU HEAR NOISE IN THE
HANDSET, AND NONE OF THE
KEYS OR BUTTONS WORK.
*Make sure the power cord is plugged in.
*Your base unit and handset may not be operating on the same channel or security code. Place the handset in the cradle for a few moments to reset the channel.
COMMON CURE FOR ELECTRIC
EQUIPMENT
Electronics, like people, can sometimes get confused. If the unit does not seem to be responding normally, then try putting the handset in the cradle. If it does not seem to respond after trying this a few times, do the following (in the order listed):
1.Disconnect the power to the base.
2.Disconnect the handset battery.
3.Wait a few minutes.
4.Connect power to the base.
5.Connect the handset battery.
6.Put the handset in the base.
12
13
WARRANTY
MAINTENANCE
WARRANTY STATEMENT
WHAT DOES OUR WARRANTY
COVER?
* Any defect in material or workmanship.
FOR HOW LONG AFTER THE
ORIGINAL PURCHASE?
*To the original purchaser only - ONE YEAR.
WHAT WILL VTECH DO?
*At our option, repair or replace your unit.
HOW DO I SEND MY UNIT, IN OR
OUT OF WARRANTY?
* In the U.S. call VTECH COMMUNICATIONS CUSTOMRER SERVICE For Return Authorigation at:
In Canada call VTECH ELECTRONICS at
In Canada VTECH ELECTRONICS
SUITE 2007671 Alderbridge Way
Richmord, B.C. U6X 1Z9
VTECH Communications assumes no responsibility for units sent without
prior Return Authorization.
WHAT DOES OUR WARRANTY
NOT COVER?
* Batteries |
* Damage from misuse, neglect, or acts |
of nature (lightning, floods, power |
surges, etc.) |
* Products which may have been modi- |
fied or incorporated into other products |
* Products purchased and/or operated |
outside the USA, its territories, or |
Canada. |
* Products serviced by the owner or a |
service facility not expressly authorized |
by VTECH Communications |
TAKINGCAREOFYOURTELEPHONE.
Your VTech VT 1711 cordless telephone contains sophisticated electronic parts, so it must be treated with care.
Avoid rough treatment. Place the handset down gently. Save the original packing materials to protect your telephone if you ever need to ship it.
Avoid Water
Your telephone can be damaged if it gets wet. Do not use the handset outdoors in the rain, or handle it with wet hands. Do not install your base unit near a sink, bathtub, or shower.
Electrical storms
Electrical storms can sometimes cause power surges harmful to electronic equipment.
For your own safety, use caution when using electric appliances during storms.
Cleaning your telephone
Your telephone has a durable plastic casing that should retain its luster for many years. Clean it only with a soft cloth slightly dampened with water or a mild soap. Do not use excess water or cleaning solvents of any kind.
ReMEM/PROGber that electrical appliances can cause serious injury if used when you are wet or standing in water, DO NOT RETRIEVE IT UNTIL YOU UNPLUG THE POWER CORD AND TELEPHONE LINE CORDS FROM THE WALL. Then pull the unit out by the unplugged cords.
* Properly pack your unit. Include any ca- |
bles and accessories that were origi- |
nally provided with the product. We rec- |
ommend using the original carton and |
packing materials. |
* Include in the package a copy of the |
* | Products purchased more than 12 |
| months from current date |
* | Units purchased in “AS IS” condition or |
| units purchased as “Distressed |
| Merchandise”. |
TECHNICAL SPECIFICATIONS
sales receipt or other evidence of date |
or original purchase (if the unit was |
purchased within the last twelve |
months). |
* Print your name and address, along with |
a description of the defect, and include |
this in the package. |
* Include payment for any service or re- |
pair not covered by warranty, as deter- |
mined by VTECH Communications. |
* Ship the unit via UPS Insured, or equiva- |
lent to: |
VTECH COMMUNICATIONS
11035 SW 11th STREET BLDG. B SUITE 270 BEAVERTON, OR 97005
HOW DOES STATE LAW RELATE TO
THIS WARRANTY?
*This warranty gives you specific rights. You may also have other rights that vary from state to state.
Direct Sequence Spread Spectrum Cord-
less Telephone
FREQUENCY CONTROL
Crystal Controlled PLL Synthesizer
TRANSMIT FREQUENCY
902MHz to 928MHz
NOMINAL EFFECTIVE RANGE
Maximum power allowed by FCC and IC. Actual operating range may vary according to environmental conditions at the time of use.
size
Handset: 186.5(L)X64(W)X45(D)mm
Base: 205(L)X156(W)X57(H)mm
WEIGHT
Handset: 280g
Base:415g
POWER REQUIREMENTS
Handset: | |
| cadmium rechargeable |
| battery supply, 3.6V |
| nominal, 600mAh |
| capacity. |
Base: | 9VDC @ 500mA |
MEMORY |
|
Memory Dial: | 20 Memory locations |
| 16 Digits per location |
14
15 |
