– 2 –
Installation, Operation and Care ofSCALEBLOCKERTM WATER FILTRATION SYSTEMMODELS SPS600V & SPS620V

SAVE THESE INSTRUCTIONS

GENERAL
Vulcan water filters are produced with quality workmanship and material. Proper installation,
usage and maintenance of your water filter will result in many years of satisfactory performance.
It is suggested that you thoroughly read this entire manual and carefully follow all of the
instructions provided.
The water filtration system conforms to ANSI/NSF Standard 53 and ANSI/NSF Standard 42 for
the specific performance claims as verified and substantiated by test data.
Filter capacity will vary according to flow rate, influent water pressure and local water conditions.
Service life for the filter cartridge for model SPS600V is 7,500 gallons (28,390 liters); for model
SPS620V, the service life for the filter cartridge is 15,000 gallons (56,780 liters). Filter cartridge
replacement is recommended at least every 6 months to maintain equipment warranty. Filter
cartridge replacement is also recommended if water pressure goes below 20 psig (138 kPa).
INSTALLATION
UNPACKING
The water filter was inspected before leaving the factory. The transportation company assumes
full responsibility for safe delivery upon acceptance of the shipment.
IMPORTANT: Immediately after unpacking, check for possible shipping damage. If the water
filter is found to be damaged, save the packaging material and contact the carrier within 15 days
of delivery.
TEST THE WATER AND RETURN THE RESPONSE CARD
Test the incoming unfiltered water supply with the enclosed 4-IN-1 City Water Check test strip by
carefully following the instructions on the package. Record the results on the enclosed Filter
Registration Card. Be sure and use the Vulcan-Hart Equipment model and serial number. Do
not use the filter system model and serial number. Fill the registration card out completely and
return the information to Vulcan in one of the following three ways: Mail the postage-paid self-
addressed card to Vulcan, FAX the completed card per instructions on the cord or contact Vulcan
on-line at
www.vulcanhart.com
, select service tab and answer all the necessary questions.
NOTE: Filter registration is required at time of installation to begin warranty coverage on the
equipment being installed with the filter.
LOCATION
The water filter should be mounted on a sturdy support structure or wall and must be level. Do
not mount the filter system directly on the steamer.
LEVELING
Use a carpenter's level to level the top of the water filter's mounting head.
© VULCAN-HART 2002, 2004