USING THE CORDLESS HAND VACUUM CLEANER
1.Remove the vacuum cleaner from the charging base.
2.To use the hand vacuum cleaner slide the on/off button forward.
3.To turn the unit off, slide the on/off button backwards.
4.A crevice tool is provided for cleaning narrow, hard to reach places. A dusting brush is provided for cleaning upholstery and furniture.
CAUTION: The suction hole must be open and free of any obstruction at all times. Otherwise, the motor will overheat and could become damaged.
INSTALLATION OF WALL MOUNT
Hold the wall mount on to a spot you wish to install the wall mount and draw drill points through the wall mount holes. Please make sure to be close enough to the next power outlet to connect the cord. Drill 2 holes at the marked points. Prior to drilling verify that no water, gas or power lines are close to the holes to be drilled. Install the wall mount with the supplied screws and wall anchor. Please check if the wall anchor and screws match your wall type (wood, concrete, and drywall). You might need to use different screws and wall anchors that fit your application better. (see FIG 4)
FIG. 4
CHARGING THE HAND VACCUM CLEANER
NOTE: Ensure that the On/Off switch is in the “Off” position before charging.
A. Connect the cable to the charging station with the power source at the vacuum cleaner. Now connect the power cord to a 120 volt power outlet.
OR
B. Connect the cable to the wall mounted charging station as displayed in FIG. 4. Now connect the power cord to a 120 Volt power outlet. (see FIG. 5)
FIG. 5
7
