Wadia Digital DECODING COMPUTER 1) 2)

Wadia 9 DECODING COMPUTER

Unpack your Wadia 9 Decoding Computer, Wadia 9 Power Supply, and Wadia 10 Glass

Optical Interface and keep all packing materials for future use. To avoid damaging the

connectors on the rear of the product, or those on digital output cables, never tip the product

back in a way that would put stress on these connectors. Carefully inspect the product for

damage and flaws. If any are found, immediately contact your Wadia dealer.

1)2)

Make sure that the Wadia 9 Decoding Computer is not plugged into the AC power supply

and is disconnected from all associated equipment.

Place the Wadia 9 Decoding Computer on a flat, stable surface and turn it onto either of

its sides (The finish of the metal work can be protected by first placing a soft cloth or

towel down onto which the Wadia 9 can be placed).

While the Wadia 9 is still on its side, screw in the four pointed feet into the bottoms of the

four corner posts.

Turn the Wadia 9 upright and place it in the desired location. Four bases are provided to

be placed underneath the four pointed feet, for the protection of the furniture upon which

the product is to be placed.

Repeat steps 2, 3, and 4 for the Wadia 9 Power Supply and the Wadia

Glass Optical

Interface.

Connect one end of the power supply cord to the receptical on the rear of the Wadia 9

Power Supply and the other to a wall outlet. Do the same for the Wadia 10 Glass Optical

Interface.

Connect the three umbilical cords (Left Analog Power, Right Analog Power, and Digital

Power) from the back of the Wadia 9 Power Supply to the matching connectors on the

back of the Wadia 9 Decoding Computer.

Connect the single ended or balanced analog outputs of the Wadia 9 Decoding

Computer to the input of a pre-amplifier or power amplifier. Please make certain that the

power to the preamplifier or amplifier is not on, or that the amplifier is not connected to

the loudspeakers before making this connection.

Connect a digital source to the Wadia 9.

The Wadia 9 Decoding Computer powers-up at the lowest volume setting. Pressing the

VOLUME

button on the remote control will bring the unit out of the lowest volume level

(no volume). Adjust the digital volume control to a safe level, i.e., a setting near the

bottom of the scale. This can be re-adjusted after the music starts to play.