Maintenance Instructions | ADJUSTMENTS |
Neutral Travel End Adjust
FSC Switch - Neutral Adjustment - Step 6
1.Place the FSC in neutral position. Loosen mounting screws and adjust switch up or down accordingly.
FSC Switch
FSC Switch Location
Switch Closed | FSC Switch |
in Neutral | Actuator Arm |
Deck Support
Arm (Ref)
Loosen Screws
FSC Switch Adjustment
(Side View Through Chassis)
Forward Speed Control Friction Adjustment - Step 7
FSC Position With Levers
1.Place the FSC in the full forward position and pull both steering levers back; the FSC lever should not move. If the FSC lever moves back the friction needs to be increased.
2.With the steering levers held back, move the FSC lever back from the forward position. With a proper amount of friction adjusted, the FSC le- ver should move back with a slight amount of re- sistance (friction). If the FSC lever movement is "stiff", the friction needs to be decreased.
3.The FSC friction is increased or decreased by tightening or loosening the friction adjustment nut. Loosen or tighten the nut and check the control function until the conditions of both steps 1 and 2 are met.
PTO Belt Tension
PTO belt tension can be adjusted by lengthening or shortening the position of the adjustment bolt on the idler adjuster (above idler pulley). Optimum adjustment will result in a 1/2 in. (1.27 cm) deflection of the belt.
1/2 in. (1.27 cm)
deflection
PTO Belt Tension Adjustment
56