Maintenance Instructions | REPLACING/REPAIRING |
Engine PTO Drive Belt (3 Groove Power Band)
1.To remove the engine PTO drive belt:
a.Remove the jackshaft drive belt from its idler pulley (by pushing down on idler pul- ley) and let the belt drop down out of the way.
NOTE: Step (a) is not essential to removing the PTO belt, but it makes more room to work with the PTO belt.
b.Push the clutch idler pulley down (until the PTO belt tightener stop block contacts the frame) and then shift the belt off the idler pulley (to the inside).
c.Raise the clutch lever (engage position) to lift the clutch idler away from the belt.
d.Next remove the belt from the engine pul- ley and then the PTO drive pulley.
2.Install the PTO drive belt by reversing the re- moval procedure.
IMPORTANT: Make sure the belt is installed inside the four (4) belt guide pins.
Check and make the following adjustments:
a.Clutch engagement for proper belt tension
b.Clutch disengagement and brake action
|
| Clutch | PTO Belt |
|
| Linkage | |
Pull UP to Engage | PTO Belt Tightener | Tightener Arm | |
|
| ||
Stop Block |
|
| |
|
|
| |
| Engine |
| Belt |
| PTO Belt |
| Guide |
Blade Clutch Lever |
|
| Engine |
in the DOWN Position |
|
| |
|
| Pulley | |
|
|
| |
Belt Guides |
|
|
|
(Bottom Guide Not Visible) |
|
|
|
|
| Clutch Idler | |
|
| Pulley | |
|
| Belt |
|
|
| Guide |
|
| PTO Drive |
|
|
| Pulley | ||
|
| Pulley | |
Engine PTO Drive Belt Removal
60