Assembly Instructions
CHECK ENGINE COOLING SYSTEM - Model MTL and MTLEFI
∙Check the radiator air intake screen to make sure the screen is clean and free of obstruction. Also, the radiator cooling fins should be inspected and cleaned if there is any buildup of dirt or debris. (Remove the intake screen assembly to inspect and clean.)
∙Check the coolant levels in the radiator and over- flow tank. If additional coolant is needed, refer to CHECKING/SERVICING the Engine Cooling System - MTL and MTLEFI in Maintenance
Instructions.
WARNING
DO NOT remove the radiator pressure cap when engine is hot.
CHECK GEAR AXLE OIL LEVEL
Refer to LUBRICATION for Gear Axle Lubrication in Maintenance Instructions.
INSPECT FOUR (4) DRIVE BELTS
Engine PTO Drive, Jackshaft Drive, Hydrostatic Ground Drive, and GHS Blower Drive (if equipped).
CHECK HYDROSTATIC TRANSMISSION OIL LEVEL
Refer to LUBRICATION for Checking Hydrostatic Transmission Fluid Level in Maintenance Instructions .
CHECK FUNCTIONS OF INSTRUMENT PANEL AND WARNING HORN
Turn the ignition key to the RUN position. Voltmeter, Oil Pressure Light, and Warning Horn should all op- erate, indicating normal function.
CHECK FUNCTION OF SAFETY INTERLOCK SWITCHES
Refer to Operating Instructions to check for proper operation of safety switches, both during engine starting and with this operator leaving the seat with tractor moving forward or with the mower blades en- gaged.
CHECK TIRE PRESSURE
Deck Caster Wheel = 20 PSI (137 kPa)
Drive | = | 15 PSI (103 kPa) |
Rear | = | 20 PSI (137 kPa) |
CHECK AND CLEAN GRASS BUILDUP UNDERNEATH MOWER DECK (and inside GHS blower, if equipped)
Refer to CLEANING the GHS Blower in Mainte-
nance Instructions for blower cleaning information.
DANGER
Never operate cutter blades with deck in raised position because it is hazardous.
The
on Deck
Deck Lock Lever
Deck Secured in
CAUTION
Do not operate machine with deck
27