Operating Instructions
Front Body Latch Release
The front portion of the tractor body hinges forward for maintenance access and is latched down in the OPERATING position. To raise the body, move the latch release forward.
Front Body
Latch Release
Front Body Latch Release
Transmission Lockout Levers
The transmission lockout levers disengage the hydrostatic transmissons. By lifting the lever on top of the transmission and locking it into place with the lockout cam, the hydrostatic transmissions are released to permit freewheeling. By releasing the cam and lowering the lever, the transmissions are engaged for normal operation. The transmission lever in the LOCKOUT position is used to enable moving the machine without the engine running (e.g., for service). Refer to TRANSMISSION LOCKOUT in this section for operating instructions.
Lockout
Levers
Transmission
Plunger
Lockout Lever Location
NOTE: The transmission plunger on the side of the transmission case (activated by the LOCKOUT LEVER ) must be completely released during operation of the mower, otherwise operation of the transmission will be erratic.
Optional Cold Start Lever
(Jackshaft Drive Belt Release)
The cold start lever is used for starting the machine in cold weather [below 40° F (4° C)]. Pulling the lever UP disengages the jackshaft drive belt. When the jackshaft drive belt is released, the hydrostatic transmissions are removed from the engine starter cranking load.
Cold Start Lever
Disengaged
Optional Cold Start Lever
Normal Operating Position
Cold Start Lever
Engaged
Optional Cold Start Lever
Cold Start Position
32