Operating Instructions

Ignition Switch

The ignition switch is used to start and stop the en- gine. The switch has three positions: “O” is the OFF position, RUN is the position the key returns to after starting, and is the START position. When starting the engine, turn the key clockwise to the START position. Do not hold the key in the START position longer than 10 seconds. If the engine does not start, return the key to the “O” position for at least 60 seconds before making a restart attempt. Prolonged cranking can damage the starter motor and shorten battery life. Release the key when the engine starts, and it will return to the RUN position. To stop the engine, rotate the key counterclockwise to the “O” position.

OFF

RUN

START

Ignition Switch

Light Switch (For Optional Lights)

Operates headlights (when installed).

Warning Horn

The warning horn sounds to alert the operator that an unsafe engine condition is being indicated - when engine temperature is too high or engine oil pressure is too low. If the horn sounds, check the indicator lights and correct the problem before further operation.

Circuit Breaker

One manual reset circuit breaker is located on the instrument panel. A button pops out if the circuit breaker trips. The 7 amp circuit breaker protects the safety circuits and GHS. The 30 amp circuit breaker protects the instrument panel, headlights, and starter solenoid, and a 20 amp fuse protects the ECU.

STARTING THE ENGINE

CAUTION

Before operating the mower, read and un­ derstand all Safety Instructions and Operat­ ing Instructions.

WARNING

NEVER run the engine in an enclosed or poorly ventilated area. Engine exhaust contains carbon monoxide, an odorless and deadly gas.

1.Before attempting to start the engine, make sure the operator is in the seat, the Forward Speed Control is in NEUTRAL-PARKposition, and the blade clutch and parking brake are DIS-

ENGAGED.

NOTE: Release parking brake to prevent extra load on the starter if the transmission neutral is slightly out of adjustment.

CAUTION

A Safety interlock switch system PREVENTS CRANKING the engine with either the Forward Speed Control out of neutral, or the blade clutch (PTO) engaged. If the engine cranks otherwise, the safety system is not working and should be repaired or adjusted­ before operating the mower. DO NOT disconnect safety switches; they are for the operator’s protection.

33