Wayne-Dalton 8000 Strap Bracket Installation, Side Lock Installation, Screws

Strap Bracket Installation

Loosely attach (2) straps to each center hinge, with (1) 3” long carriage bolt and wing nut (see Fig. 8). Attach

(2)straps to the bottom half hinge, with (1) 3-1/2” long carriage bolt and wing nut (see Fig. 9). Position the straps at each center hinge, and bottom half hinge locations.

Ensure that the windload post is plumb while locked into the header lock bracket and hole in floor. Now, secure each strap to the windload post using (1) 1/4-20 x 11/16” self-drilling screw.

NOTE: Keep straps parallel and level. (see Fig. 10)

Finish hand tightening the carriage bolts and wing

WING

CENTERNUT HINGE

(2) STRAP

3” LG.

CARRIAGE BOLT

FIG. 8

FIG. 9

WING

NUT

HALF HINGE

(2)STRAPS

3-1/2” LG.

CARRIAGE BOLT

FIG. 10

WINDLOAD

POST

STRAP
JR. “A”	(2) 1/4-20 X 11/16”
FRAME	SELF-DRILLING SCREWS

Side Lock Installation

Install side lock on the second section from the bottom of the door. Square side lock assembly with door sec- tion and hole in vertical track. The side lock should be spaced approximately 1/8” from the section edge. Secure the side lock to the section with (4) 1/4-20 x 11/16” self drilling screws.(see Fig. 11)

IMPORTANT! Side locks and openers should not be engaged at the same time. If an opener is installed on the door and engaged, be sure side locks are disengaged, otherwise damage could result to door and/or opener. Only use side locks when opener is disengaged from the garage door.

1/8”

SIDE LOCK

ALIGN WITH
HOLE IN	(4) 1/4-20 X 11/16”
VERTICAL
	SELF DRILLING
TRACK
	FIG. 11 SCREWS

6