Wayne-Dalton owner manual Programming to Gateway, KEP-IVOperation with Gateway

Programming KEP-IV to Wireless Gateway

To program a PIN to a Scene button on the Wireless Gateway, WDHA-12R, or to reassign a PIN to a Scene button:

1.Press and Hold the Scene button you wish to program on the Wireless Gateway, either Scene 1, 2 or 3, until the LED turns off, then immediately release the Scene button (before the LED turns on again.)

2.Open the cover of the KEP-IV, then push the ON/OFF/RESET button of the keyless entry. The Keyless Entry keypad will light indicating it has been activated and is waiting for commands (illumination may not be visible in direct sunlight.)

3.Press the desired four digit PIN number. (example:1-2-3-4). Programming to the Scene is now complete.

The LED on the Wireless Gateway will flash three (3) times quickly to indicate the programming is successful.

Note: Your KEP-IV cannot directly operate Z-Wave®modules, the Z-Wave®modules must be programmed to the Gateway Scene to which you have programmed your KEP-IV PIN code. See the Gateway User Manual for instructions on programming Z-Wave®modules.

Note: Each Scene on the Gateway must be programmed with a different PIN.

LEDs

Scene	1	
Scene 2
Scene 3
Copy			1
Delete

CHOOSE 1

SCENE BUTTON

USE KEYPAD TO
INPUT 4 DIGIT
PIN CODE
3	
	2	
ON/OFF/RESET

Programming to Gateway

KEP-IV Operation with Gateway

To operate a Wireless Gateway Scene:

1.Activate your keypad by pressing the ON/OFF/RESET button and the keypad will illuminate.

2.Enter the 4 digit PIN (personal identification number) for the specific Scene you want to activate.

3.Your Keypad will turn off automatically in 15 seconds, or you may manually turn it off.

USE KEYPAD TO
INPUT 4 DIGIT
PIN CODE	
2
		
	1
ON/OFF/RESET

6