Tank panel tabs
Figure 10
Slide tank panel up until notch at bottom of panel fits over the cross brace. Insert one bolt with washer through the hole in the bottom of the tank panel, through the wheel frame and into the end of the frame connector. Insert the other bolt with washer through the leg frame and into the other end of the frame connector. Hold the frame connector square and tighten the bolts. Figure 11.
Frame
connector
Cross brace
Figure 11
Slots in frame brace
Frame brace
Insert the tank panel tabs into the slots in the frame brace. Figure 10.
Step 9
Install tank panel assembly and frame connector
You will need: tank panel assembly, frame connector, two 1/4-20 x 1 3/4 inch bolts, two nylon washers and a 7/16 inch wrench.
Step 8
Install manifold bracket
You will need: manifold bracket
Hook the bracket onto the manifold at the center burner valve. Figure 9. Place your hand underneath the bracket. Lift the manifold, bracket and cooking box slightly and hook the tab of the bracket onto the frame brace.
Frame brace
Manifold bracket
Figure 9
13
