
Reinstall control panel (after checking for gas | Install Right Work Surface |
| ||
leaks) | You will need right work surface, two 1/2 inch bolts, | |||
(1) | Set the control panel in place over both sides of | two nylon washers and a 7/16 inch or adjustable | ||
| the frame. Hold the crossover ignition button up | wrench. |
| |
| while setting the control panel in place. | Insert the right work surface tabs in the slots In the | ||
(2) | Line up the control panel with the white plastic | frame(1). Slip washers on the bolts and insert the bolts | ||
| plugs in the frame brace. Insert screws and tighten | as shown(2). Tighten |
| |
| with a Phillips screwdriver until snug. Do not |
|
| |
| overtighten. |
| (2) | |
(3) | Push each of the burner control knobs onto their | (1) | ||
| ||||
| valve. |
|
| |
(4) | Reinstall Side Burner cover. |
|
|
(1)
(3)
(2)