22 | HANDLE LIGHT TROUBLESHOOTING | |
|
|
|
PROBLEM | CHECK | CURE |
|
|
|
Rotisserie burner does not light. | Did you hold the burner control knob in and | Try to relight burner by holding burner control knob in and continue holding in until |
| hold in for 20 seconds until after burner | 20 seconds after burner has ignited. |
| ignited? |
|
|
|
|
| Did you wait to see the entire ceramic surface | When relighting burner by holding burner control knob in, wait to see the entire |
| become alight before counting 20 seconds? | ceramic surface become alight before counting 20 seconds? |
|
|
|
| Did you repeatedly use the snap ignition until | After waiting fi ve minutes for gas to clear, try repeatedly using the snap igniter until |
| the burner ignited? | the burner ignites (refer to “Lighting the Rotisserie Burner”). |
|
|
|
| Does the igniter work (Do you see a spark | Try manually lighting the burner (refer to “Lighting the Rotisserie Burner”). Call |
| when you repeatedly use the snap igniter? | customer service. |
|
|
|
General Symptoms: | The excess fl ow safety device, which is part of | To reset the excess fl ow safety device turn all burner control knobs and the cylinder |
Burner does not light. | the barbecue to cylinder connection, may have | valve to “OFF”. Disconnect the regulator from the cylinder. Turn burner control |
a small flickering flame | activated. | knobs to “START/HI”. Wait at least 1 minute. Turn burner control knobs to “OFF”. |
|
| Reconnect the regulator to the cylinder. Turn cylinder valve on slowly. Refer to |
|
| “Lighting Instructions”. |
|
|
|
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.
ROTISSERIE TROUBLESHOOTING
WEBER® SPIDER /INSECT SCREENS
Your Weber® gas barbecue, as well as any outdoor gas appliance, is a target for spiders and other insects. They can nest in the venturi section (1) of the burner tubes. This blocks the normal gas fl ow, and can cause the gas to flow back out of the combustion air opening. This could result in a fi re in and around the combustion air openings, under the control panel, causing serious damage to your barbecue.
The burner tube combustion air opening is fi tted with a stainless steel screen (2) to prevent spiders and other insects access to the burner tubes through the combustion air openings.
We recommend that you inspect the Spider/Insect screens at least once a year. (See Section “Annual Maintenance”.) Also inspect and clean the the Spider/Insect screens if any of the following symptoms should ever occur:
1)The smell of gas in conjunction with the burner fl ames appearing yellow and lazy.
2)Barbecue does not reach temperature.
3)Barbecue heats unevenly.
4)One or more of the burners do not ignite.
DANGER
Failure to correct the above mentioned symptoms may result in a fire, which can cause serious bodily injury or death, and cause damage to property.
1 |
2 |
WWW.WEBER.COM®
