TRANSPORTING AND
STORAGE
SAllowtheenginetocool;secure unitbefore storing or transporting in vehicle.
S Empty the fuel tank before storing or transporting the unit. Useup fuelleft inthe
carburetorbystartingtheengineandletting it run until it stops.
SStore unit and fuel in an area where fuel vaporscannotreachsparksoropenflames
from water heaters, electric motors or switches, furnaces, etc.
SStoreunitsolinelimiter cannotaccidentally
causeinjury. Unit canbe hungby thetube.
SStore the unit out of the reach of children.
If situations occur which are not covered in this manual, use care and goodjudgment. If
youneedassistance,call1- 800- 554- 6723.
SPECIAL NOTICE: This unit is not
equipped with a temperature limiting muffler
andspark arresting screenwhich meets the requirements of California Codes 4442 and
4443. All U.S. forest land and the states of
California, Idaho, Maine, Minnesota, New Jersey,Oregon, andWashington requireby
lawthatmany internalcombustionenginesto
be equipped with aspark arrestor screen. If you operate in a locale where such
regulations exist,youarelegally responsible for installing and maintaining the operating
condition of these parts. Failureto doso is a
violation of the law. If a spark arrestor is required in your area, contact your
Authorized ServiceDealer for the proper kit.
SPECIAL NOTICE: Exposure to
vibrations throughprolongeduseofgasoline poweredhandtoolscouldcausebloodvessel
or nerve damage in the fingers, hands, and joints ofpeoplepronetocirculationdisorders
or abnormalswellings. Prolongeduseincold
weather has been linked to blood vessel damage in otherwise healthy people. If
symptoms occur such as numbness, pain,
loss of strength, change in skin color or texture,or loss offeelinginthefingers,hands,
or joints, discontinue the use of this tool and seek medical attention. An anti- vibration
systemdoes notguaranteetheavoidanceof
these problems. Users who operate power tools on a continual and regular basis must
monitor closely their physical condition and the condition of this tool.
WARNING: Make sure your unit is properly assembled and all fasteners are secure.
ADJUST THE HANDLE
SLoosen wing nut on handle.
S Rotate handle to upright position and tighten in a comfortable position between the trigger and thesafety labelon thetube. Tighten handle securely.
ATTACH THE SHIELD
WARNING:Theshieldmustbeproperly installed. The shield provides partial protection from the risk of thrown objects to
theoperator andothers andis equippedwith a line limiter which cuts excess line. Theline
limiter (on underside of shield) is sharp and can cut you.
SAssemble parts as shown S Tighten parts securely
Shield
NOTE: Remove | Wing Nut |
anduse washer and |
|
wing nut from this |
|
bolt for assembling Washer |
|
shield. |
|
|
|
This engine is certified to operate on unleaded gasoline. Gasolinemust bemixed
withagoodquality2- cycleair- cooledengine oil designed to be mixed at a ratio of 40:1.
Poulan/Weed Eater brand oil is recommended. (A 40:1 ratio is obtained by
mixing 3.2 ounces of oil with 1 gallon of
unleaded gasoline). Whenmixing fuelfollow the instructions printed on the container.
Always readandfollowthesafety rulesunder
FUEL SAFETY.
STARTING
POSITION
HOW TO STOP YOUR UNIT
Pushandholdenginestop switchin theSTOP or OFFposition untilthe unithas fully stopped.
3
