Weed Eater 530087060 Assembly, Blower Tube, Operating Tips Before Starting Engine, Fueling Engine

with a spark arrestor; however, a spark arres-

nia(Public Resources Codes 4442 and 4443), must be assembled to unit to be in full com- Idaho, Maine, Minnesota, New Jersey, Ore- pliance with regulations.

gon, and Washington: Certain internal com- SPECIAL NOTICE: Exposure to vibrations

bustion engines operated on forest, brush, through prolonged use of gasoline powered and/or grass covered land in the above areas hand tools could cause blood vessel or nerve are required to be equipped with a spark arres- damage in the fingers, hands, and joints of tor, maintained in effective working order, or people prone to circulation disorders or abnor- the engine must be constructed, equipped, mal swelling. Prolonged use in cold weather and maintained for the prevention of fire. has been linked to blood vessel damage in oth- Check with your state or local authorities for erwise healthy people. If symptoms occur regulations pertaining to these requirements. such as numbness, pain, loss of strength,

change in skin color or texture, or loss of feel- Failure to follow these requirements is a viola- ing in the fingers, hands, or joints, discontinue tion of the law. This unit is not factory equipped the use of this tool and seek medical attention.

An anti- vibration system does not guarantee tor is available as an optional part. If a spark ar- the avoidance of these problems. Users who restor is required in your area, contact an Au- operate power tools on a continual and regular thorized Service Dealer for the correct kit. The basis must monitor closely their physical con- spark arrestor, blower tubes, and nozzles dition and the condition of this tool.

NOTE: It is normal for the fuel filter to rattle in the empty fuel tank.

ASSEMBLY

WARNING: If received assembled, repeat all steps to ensure your unit is properly assembled and all fasteners are secure.

D No tools are required for assembly.

BLOWER TUBE

DPush the blower tube into the blower outlet until it snaps into place.

Blower Outlet

Blower Tube

OPERATING TIPS		BEFORE STARTING ENGINE
S	Operate power equipment only at reasonable	WARNING: Be sure to read the fuel
	hours--not early in the morning or late at night
	when people might be disturbed. Comply with	information in the safety rules before you
	times listed in local ordinances. Usual recom-	begin. If you do not understand the safety
	mendations are 9:00 a.m. to 5:00 p.m.,	rules, do not attempt to fuel your unit. Call
	Monday though Saturday.	1-800-554-6723.
S To reduce noise levels, limit the number of
	pieces of equipment used at any one time.	FUELING ENGINE
S	To reduce noise levels, operate power blow-	This engine is certified to operate on unleaded
	ers at the lowest possible throttle speed to do	gasoline. Gasoline must be mixed with a good
	the job.	quality 2-cycle air-cooled engine oil designed to
		be mixed at a ratio of 40:1. Poulan/Weed Eater
S	Use rakes and brooms to loosen debris be-
	fore blowing.	brand oil is recommended. (A 40:1 ratio is ob-
		tained by mixing 3.2 ounces of oil with 1 gallon of
S	In dusty conditions, slightly dampen sur-
	faces when water is available.	unleaded gasoline). When mixing fuel follow the
		instructions printed on the container. Always read
S Conserve water by using power blowers
	instead of hoses for many lawn and garden ap-	and follow the safety rules under FUEL SAFETY.
	plications, including areas such as gutters,	Fuel stabilizer is an acceptable alternative in
	screens, patios, grills, porches, and gardens.	minimizing the formation of fuel gum deposits
S	Use the full blower nozzle extension so the	during storage. Poulan/Weed Eater brand oil is
	air stream can work close to the ground.	already blended with fuel stabilizer.

S After using blowers and other equipment, CLEAN UP! Dispose of debris in trash re- ceptacles.

-- 3 --