Weed Eater 530087724 manual Maintain Your Unit Properly, Preparation Blower Tube Assembly

MAINTAIN YOUR UNIT PROPERLY

DHave all maintenance other than the rec- ommended procedures described in the Operator’s Manual performed by your

Service Dealer.

D Disconnect spark plug before performing maintenance except for carburetor adjust- ments.

D Use only recommended WEED EATER replacement parts; use of any other parts may void your warranty and cause dam- age to your unit.

DEmpty the fuel tank before storing the unit. Use up fuel left in carburetor by starting the

engine and letting it run until it stops.

DDo not use any accessory or attachment other than those recommended by the

manufacturer for use with your unit.

DDo not store the unit or fuel in a closed area where fuel vapors can reach sparks or an open flame from water heaters, electric

motors or switches, furnaces, etc.

DStore in a dry area out of reach of children.

SPECIAL NOTICE: For users on U.S. Forest Land and in some states, including California(Public Resources Codes 4442 and 4443), Idaho, Maine, Minnesota, New Jersey, Oregon, and Washington: Certain in- ternal combustion engines operated on for- est, brush, and/or grass covered land in the above areas are required to be equipped with a spark arrestor, maintained in effective working order, or the engine must be con- structed, equipped, and maintained for the prevention of fire. Check with your state or local authorities for regulations pertaining to these requirements. Failure to follow these requirements is a violation of the law. This unit is not factory equipped with a spark ar- restor; however, a spark arrestor is available as an optional part. If a spark arrestor is re- quired in your area, contact your Authorized Service Dealer for the correct kit. The spark arrestor, blower tubes, and nozzles must be assembled to the unit to be in full compliance with the regulations.

SPECIAL NOTICE: Exposure to vibra- tions through prolonged use of gasoline powered hand tools could cause blood ves- sel or nerve damage in the fingers, hands, and joints of people prone to circulation dis- orders or abnormal swelling. Prolonged use in cold weather has been linked to blood ves- sel damage in otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or tex- ture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An antivibration sys- tem does not guarantee the avoidance of these problems. Users who operate power tools on a continual and regular basis must monitor closely their physical condition and the condition of this tool.

PREPARATION

WARNING: Stop the engine and be sure the impeller blades have stopped turn- ing before opening the vacuum inlet door or attempting to insert or remove the vacuum tubes. The rotating blades can cause seri- ous injury.

WARNING: If you receive your unit assembled, check each step to insure your unit is properly assembled. Follow all safety information in the manual and on the unit.

BLOWER TUBE ASSEMBLY

D Assemble the blower tube and nozzle to the unit (turn clockwise to tighten).

Blower

Blower Outlet

Tube

Nozzle

SHOULDER STRAP ASSEMBLY (for blower use only)

D Pass the shoulder strap over your head and onto your left shoulder.

DSnap the hook onto the retainer on the top handle.

Retainer

VACUUM BAG ASSEMBLY

DOpen the zipper on the vacuum bag and in-

sert the elbow tube.

D Push the end of the elbow tube with the grooves through the small bag tube open- ing. Make sure the bag tube opening is flush against large raised rib on the tube.

DClose the zipper on the bag. Make sure the zipper is closed completely and the zipper seam is tucked toward inside of the bag.

Raised Rib	Bag Tube
Zipper	Opening
Opening

-- 3 --