BLOWER ASSEMBLY

S Insert the blower tube into the blower outlet.

STwist the blower tube clockwise until it is

firmly seated in the blower outlet.

S Twist the nozzle into the end of the blower tube until it is firmly seated. Make sure the nozzle points upward.

Blower outlet

Blower Tube Nozzle

For Model 2695 only, the blower exten- sion tube and nozzle are combined into one component.

Blower Tube/Nozzle

ATTACH VACUUM TUBES

SOn some units an arrow on the tube and the unit will help you align the tube be-

fore twisting clockwise.

S Some units may include locking tabs. These tabs guide and lock the tubes into position.

Once the upper tube is secure on the unit, and cannot be turned clockwise further, the lower vacuum tube may be installed onto the upper tube.

Not all unit will have arrows Arrow

Arrow

Upper Lower

tube tube

VACUUM ASSEMBLY

ATTACH VACUUM BAG

(Some models)

Slide the vacuum bag over the blower

OPEN THE LATCH

outlet as shown. Secure the bag to the

Insert a screwdriver in to the latch area on

blower outlet by placing the strap through

the vacuum inlet cover. Gently tilt handle

the metal ring. Pull tight and fasten as

of screwdriver toward the front of the

shown. Make sure the blower outlet is

blower to release the latch. Pull up on the

pushed far into the bag before tightening

vacuum inlet cover with your other hand.

the strap. Some units may include elastic

 

on bag without metal ring.

Impeller

Latch

Strap

 

Area

 

Metal Ring

 

 

 

Vacuum

 

 

 

 

 

Bag

 

Blower Outlet

 

Locking Tabs

 

 

 

D Carefully

loop

the

shoulder

strap

REMOVE THE INLET RESTRICTOR through the buckle as shown.

(Some models)

Last In

An inlet restrictor is used when operating your unit as a blower. This restrictor is not

used during vacuum operation and must First In be removed during vacuum assembly.

Once the cover is opened, look for the in- let restrictor between the door and the im- peller.

D Remove the inlet restrictor by rotating

counterclockwise (see illustration). D Position the unit on your right-hand

Keep this inlet restrictor for use when

side, blower outlet and bag pointing to-

using your unit as a blower later. With

ward the rear. Hold the unit in an upright

the restrictor removed, the upper vacu-

position, and support the lower vacuum

um tube will twist onto the unit.

tube on the ground.

5

Page 5
Image 5
Weed Eater 2525, 530087937, 2510 Blower Assembly, Attach Vacuum Tubes, Vacuum Assembly Attach Vacuum BAG, Open the Latch