CHECK FOR DAMAGED OR WORN PARTS
Contact an authorized service dealer for re- placement of damaged or worn parts.
SThrottle Lever
the STOP position. Make sure engine stops; then restart engine and continue.
SFuel Tank
INSPECT AND CLEAN UNIT AND DECALS
S After each use, inspect complete unit for loose or damaged parts. Clean the unit us- ing a damp cloth with a mild detergent.
SWipe off unit with a clean dry cloth.
CLEAN AIR FILTER
Air Filter
Screw
Air Filter Cover
Cleaning the air filter:
A dirty air filter decreases engine perform- ance and increases fuel consumption and harmful emissions. Always clean after every 5 hours of operation.
1.Clean the cover and the area around it to keep debris from falling into the carbure- tor chamber when the cover is removed.
2.Remove parts as illustrated.
NOTE: Do not clean filter in gasoline or other flammable solvent. Doing so can create a fire hazard or produce harmful evaporative emis- sions.
3.Wash the filter in soap and water.
4.Allow filter to dry.
5.Apply a few drops of oil to the filter; squeeze filter to distribute oil.
6.Replace parts.
REPLACE SPARK PLUG
Replace spark plug each year to ensure the engine starts easier and runs better. Set spark plug gap at 0.025 inch. Ignition timing is fixed, nonadjustable.
1.Twist, then pull off spark plug boot.
2.Remove spark plug from cylinder and dis- card.
3.Replace with Champion
4.Reinstall the spark plug boot.
INSPECT MUFFLER AND SPARK ARRESTING SCREEN
WARNING: The muffler on this product contains chemicals known to the State of California to cause cancer.
As your unit is used, carbon deposits build up on the muffler and spark arresting screen and must be removed to avoid creating a fire haz- ard or affecting engine performance.
For normal homeowner use, the muffler and spark arresting screen will not require any service. After 50 hours of use, we recom- mend that your muffler be serviced or re- placed by your authorized service dealer.
CARBURETOR ADJUSTMENTS
There is no screw for idle adjustment on your blower. The throttle lever is used to control engine speed. The throttle lever can be placed in one of four positions: STOP, IDLE
or , FULL THROTTLE or | , and one |
intermittent position. If your engine will not run properly or you require further assistance, contact an authorized service dealer or call
6723. |
STORAGE
WARNING: Perform the following steps after each use:
SAllow engine to cool, and secure the unit
before storing or transporting.
SStore unit and fuel in a well ventilated area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc.
SStore unit with all guards in place. Position unit so that any sharp object cannot acci-
dentally cause injury.
SStore unit and fuel well out of the reach of children.
SEASONAL STORAGE
Prepare unit for storage at end of season or if it will not be used for 30 days or more.If your unit is to be stored for a period of time:
SClean the entire unit before lengthy storage. S Store in a clean dry area.
S Lightly oil external metal surfaces.
FUEL SYSTEM
Under FUELING ENGINE in the OPERA- TION section of this manual, see message la- beled IMPORTANT regarding the use of ga- sohol in your engine.
Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or fuel storage container. Follow the mix instructions found on stabilizer container. Run engine at least 5 minutes after adding stabilizer.
HELPFUL TIP
During storage of your gas/ oil mixture, the oil will sepa- rate from the gas.
We recommend that you shake the gas can weekly to insure proper blending of the gas and oil.
