CORRECT OPERATING POSITION
When operating unit, stand as shown and check for the following:
SWear eye protection and heavy clothing. S Grip rear handle with right hand and front
handle with left hand.
S Keep unit below waist level.
SDo not cut stems greater than 3/8 inch (1 cm) thick.
SDuring operation, keep extension cord be- hind the trimmer; never drape over hedge being trimmed.
Top Cutting
Use a wide sweeping motion for top cutting. A slight downward tilt of the cutting blades in the direction of motion gives the best cutting results.
STOPPING YOUR UNIT
To stop the unit, release the trigger switch, al- low blades to stop, then move the hedge trim- mer away from the cutting area.
STARTING YOUR UNIT
1.Connect the unit to a power source using the proper size extension cord (see SE-
LECT AN EXTENSION CORD).
2.Grip front and rear handles firmly.
3.Push the trigger
4.Squeeze and hold the trigger switch.
OPERATING THE UNIT
SRead important safety instructions before operating.
Side Cutting
When trimming the sides of a hedge, begin at the bottom and cut upwards.
MAINTENANCE
CUSTOMERRESPONSIBILITIES
WARNING: Disconnect power source before performing maintenance.
CARE & MAINTENANCE TASK | WHEN TO PERFORM |
|
|
Check for loose fasteners and parts | Before each use |
Check for damaged or worn parts | Before each use |
Inspect and clean unit and labels | After each use |
|
|
Lubricate blades | After each use |
GENERAL RECOMMENDATIONS
The warranty on this unit does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, the operator must maintain unit as instructed in this manual. Various adjust- ments will need to be made periodically to properly maintain your unit.
BEFORE EACH USE
CHECK FOR LOOSE
FASTENERS AND PARTS
SHousing screws S Handguard
S Blade
CHECK FOR DAMAGED OR
WORN PARTS
Contact an authorized service dealer for re- placement of damaged or worn parts.
STrigger Switch
properly by pressing and releasing the trig- ger switch. Make sure motor stops.
SPigtail plug and extension cord
AFTER EACH USE
INSPECT AND CLEAN UNIT AND LABELS
SAfter each use, inspect complete unit for loose or damaged parts. Clean the unit us- ing a damp cloth with a mild detergent.
7