MAINTENANCE
WARNING: Disconnect unit from power source before performing mainte- nance.
GENERAL RECOMMENDATIONS
The warranty on this unit does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, the operator must maintain unit as instructed in this manual. Various adjust- ments will need to be made periodically to properly maintain your unit.
BEFORE EACH USE
CHECK FOR LOOSE
FASTENERS AND PARTS
SHousing Screws S Debris Shield
CHECK FOR DAMAGED OR WORN PARTS
Contact an authorized service dealer for re- placement of damaged or worn parts.
S Trigger Switch
SDebris Shield
AFTER EACH USE
INSPECT AND CLEAN UNIT AND LA- BELS
SAfter each use, inspect complete unit for loose or damaged parts. Never use a dam-
aged trimmer.
SClean the unit using a damp cloth with a
mild detergent.
SWipe off unit with a clean dry cloth.
SUse a soft brush to clean around the inside of the debris shield, the cutting head and the motor housing air vents.
SERVICE AND ADJUSTMENTS
WARNING: Disconnect unit from power source before servicing.
REPLACING THE LINE
1.Press and hold in the two cap release latches.
2.Pull cap away from the hub.
| Cap | |
| Cap | |
Spool | release | |
latch | ||
|
Hub
Eyelet
3.Remove old spool.
4.Clean entire surface of hub and spool.
5.Replace with a
WARNING: Never use wire, rope, string, etc., which can break off and become a dangerous missile.
6.Insert one end of the line about 1/2 inch (1 cm) into one of the small holes in the up- per section of the inside of the spool.
7.Wind the line evenly and tightly onto the spool. Wind in the direction of the arrow found on the spool.
8.Push the line into the notch, leaving 3 to 5 inches (7
9.Repeat on the lower section of the spool.
Notches
9
