SWEEPING |
|
The fanning action of the rotating line can be | Sweeping |
used for a quick and easy clean up. Keep the |
|
line parallel to and above the surfaces being |
|
swept and move the tool from side to side. |
|
MAINTENANCE
WARNING: Disconnect unit from the power source before performing mainte- nance.
GENERALRECOMMENDATIONS
The warranty on this unit does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, the operator must maintain unit as instructed in this manual. Various adjust- ments will need to be made periodically to properly maintain your unit.
BEFORE EACH USE
CHECK FOR LOOSE
FASTENERS AND PARTS
•Housing Screws
•Locking Sleeve Assembly
•Assist Handle
•Debris Shield
CHECK FOR DAMAGED OR WORN PARTS
Contact an authorized service dealer for re- placement of damaged or worn parts.
•Trigger Switch
•Debris Shield
AFTER EACH USE
INSPECT AND CLEAN UNIT AND LA- BELS
•After each use, inspect complete unit for loose or damaged parts. Clean the unit us- ing a damp cloth with a mild detergent.
•Wipe off unit with a clean dry cloth.
SERVICE AND ADJUSTMENTS
REPLACING THE LINE
1.Disconnect the unit from the power source.
2.Remove the spool by firmly pulling on the tap button.
3.Clean entire surface of hub and spool.
4.Replace with a
WARNING: Never use wire, rope, string, etc., which can break off and become a dangerous missile.
5.Insert one end of the line about 1/2 inch (1 cm) into the small hole inside the spool.
6.Wind the line evenly and tightly onto the spool. Wind in the direction of the arrow found on the spool.
7.Push the line into the notch, leaving 3 to 5 inches (7
8.Insert the line into the exit hole in the hub as shown in the illustration.
9.Align the notch with the line exit hole.
10.Push the spool into the hub until it snaps into place.
11.Pull on the line extending outside the hub to release it from the notch; otherwise, the unit will not function properly.
Small
Hole
Spool
Tap 
Button
Line in Notch
Hub | Line exit hole |
|
7
