Weider 831.15395.1 user manual Front of the Front Leg Foot is taller than Back

2. Attach a Wheel (31) to the outside of the Base (1)	2
with an M10 x 108mm Bolt (81), three M10
Washers (75), and an M10 Nylon Locknut (76).
Do not overtighten the Locknut; the Wheel
must be able to turn easily.				76	75
Attach the other Wheel (not shown) in the same							75
manner.
					31		81
				1
3. Press a 38mm x 64mm Inner Cap (41) into each
	3
end of the Cross Tube (11).					75		47
Orient the Cross Tube (11) as shown, with the	3		41
welded tubes at the bottom. Attach the Cross							Welded
Tube to the Upright (3) with two M10 x 140mm
Carriage Bolts (73), two M10 Washers (75), and	73						Tube
two M10 Nuts (47).					11
							41
			73
4. Press a 38mm x 76mm Inner Cap (99) into the
	4
top of the Front Leg (6). Press the Front Leg Foot
(27) onto the bottom of the Front Leg. Note that					5
the front of the Front Leg Foot is taller than		99					99
the back.			76
Press a 38mm x 76mm Inner Cap (99) into the							Hook
end of the Bench Rail (5).			76
Attach the Bench Rail (5), with the hook on the	61
bottom, to the Front Leg (6) with two M10 x			6
53mm Carriage Bolts (61) and two M10 Nylon	Front
Locknuts (76).			27
5. Lubricate an M10 x 103mm Bolt (66) with grease.	5					30
Attach the Bench Rail (5) to the Upright (3) with							3
the Bolt and an M10 Nylon Locknut (76). Do not		Insert the bolt		76
overtighten the Locknut; the Bench Rail must
be able to pivot easily.		through this hole
Tighten the Storage Knob (30) into the Upright (3)		5					66
and the Bench Rail (5).
						Lubricate
	6