Assembly
Make Things Easier
Everything in this manual is designed to ensure that the weight bench can be assembled successfully by anyone. However, the weight bench has many parts, and the assembly process will take time. Setting aside plenty of time will make the process go more smoothly.
•Assembly requires two people.
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
•Tighten all parts as you assemble them, unless instructed to do otherwise.
•For help identifying small parts, use the PART IDENTIFICATION CHART on page 5.
•As you assemble the weight bench, make sure all parts are oriented as shown in the drawings.
The following tools (not included) are required for assembly:
•Two adjustable wrenches 
•One rubber mallet 
•One standard screwdriver 
•One phillips screwdriver 
•Lubricant, such as grease or petroleum jelly, and soapy water.
Assembly will be more convenient if you have a socket set, a set of
1.Press a 50mm Square Inner Cap (1) into the indi- cated end of the Front Leg (19). Insert a 50mm Thick Inner Cap (35) into the bottom of the Front Leg.
Attach the Front Leg (19) to the Bench Frame (5) using two M10 x 65mm Bolts (23), two M10 Washers (6), and two M10 Nylon Locknuts (11).
2.Press a 50mm Square Outer Cap (2) onto each end of the Stabilizer (24). Attach the Stabilizer to the Bench Frame (5) using two M10 x 58mm Carriage Bolts (8) and two M10 Nylon Locknuts (11).
1 |
|
|
| 23 |
|
6 | 5 |
|
|
| |
| 23 |
|
11 | 19 |
|
|
| |
1 | 35 |
|
|
| |
2 | 5 | 11 |
|
| |
| 2 | 24 |
| 8 | 2 |
6
