Weider WEBE14080 user manual Following Tools not Included are Required for Assembly

Assembly

Before beginning assembly, carefully read the following information and instructions:

•Place all parts in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed.

•Tighten all parts as you assemble them, unless instructed to do otherwise.

•For help identifying the small parts used in assembly, use the PART IDENTIFICATION CHART on the previous page.

•As you assemble the weight bench, be sure that all parts are oriented as shown in the drawings.

THE FOLLOWING TOOLS (NOT INCLUDED) ARE REQUIRED FOR ASSEMBLY:

•Two (2) adjustable wrenches

•One (1) standard screwdriver

•One (1) rubber mallet

•Lubricant, such as grease or petroleum jelly, and soapy water will also be needed.

Assembly will be more convenient if you have the following tools: A socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches.

1.Before you assemble the weight bench, be sure that you have read and understand the informa- tion in the box above.

Press a 1 3/4” Square Inner Cap (21) into each side of the “H”-Frame (1).

Attach each “L”-Bracket (12) to the indicated side of the “H”-Frame (1) with two 5/16” x 2 1/4” Bolts (16) and two 5/16” Jam Nuts (25) as shown. Be sure that the “H”-Frame (1) is oriented as shown. The high side of the weight rests must be on the side indicated.

2.Press a 1 1/2” Square Outer Cap (45) onto each end of the Stabilizer (3).

Attach the Stabilizer (3) to the Main Frame (2) with the two 5/16” x 2” Carriage Bolts (27) and two 5/16” Nylon Locknuts (19).

1	High Side of
	Weight Rests

1

25

12

1225

16 21

16 21

2

2

19

45

3

27 45

6