18.Press two 38mm Square Inner Caps (44) into the ends of the Seat Frame (17).

Orient the Seat (37) with the wide end on the side shown. Attach the Seat (37) to the Seat Frame (17) with four M6 x 16mm Bolts (72).

19.Lubricate an M10 x 154mm Bolt (69). Attach the Seat Frame (17) to the Backrest Frame (16) with the Bolt, two M10 Washers (79), and an M10 Nylon Locknut (77). Do not overtighten the

Nylon Locknut; the Seat Frame must be able to pivot easily.

20.Attach the Right and Left Power Assist Legs (20, 21) to the Leg Lever (19) with two M10 x 100mm Bolts (66) and two M10 Nylon Locknuts (77).

21.Refer to the CABLE DIAGRAMS on page 16 of this manual to identify the different cables included with the weight bench.

Locate the Bench Cable (58). Route the Cable through the Front Leg (18) and attach it to the Leg Lever (19) with an M10 x 91mm Bolt (67), two 35mm Spacers (82), two M10 Washers (79), and an M10 Nylon Locknut (77).

Press a 2” x 3” Inner Cap (50) into the bottom of the Leg Lever (19).

18

 

 

 

 

37

 

 

 

 

Wide End

 

 

 

 

 

 

 

 

44

44

 

 

17

 

 

72

72

 

 

 

 

 

 

19

 

 

 

 

 

 

17

 

 

 

77

 

 

 

 

79

 

 

 

 

16

 

 

 

 

 

79

 

 

 

 

Lubricate

69

 

 

 

20

20

 

 

 

 

 

 

 

77

 

 

 

 

 

19

 

 

 

 

 

 

 

21

 

 

 

 

66

21

 

 

 

 

 

19

 

 

 

77

 

18

 

 

 

 

 

 

79

82

82

79

 

 

 

 

58

 

 

 

 

50

 

67

 

 

 

 

 

11

Page 11
Image 11
Weider WEBE29910 user manual Nylon Locknut the Seat Frame must be able to pivot easily