Weider WEBE34100 manual

22.Lift the High Cable (54) in the location shown. Attach two Pulleys (53) inside the Weight Guide Frame (14) using two M10 x 75mm Bolts (73), four M10 Flat Washers (76), four 18mm Spacers (80), and two M10 Nylon Locknuts (68).

23.Pull the High Cable (54) down in the indicated loca- tion, so there is no slack at the ends of the High Cable.

Locate the Low Cable (55). Insert the metal-sleeve end of the Low Cable into the indicated hole in the Weight Guide Base (4). Attach the Low Cable using an M10 x 75mm Bolt (73), two M10 Flat Washers (76), two 28mm Spacers (79), and an M10 Nylon Locknut (68).

Route the ball-end of the Low Cable (55) through the bracket on the Center Base (2). Attach a Pulley inside the bracket using an M10 x 45mm Bolt (71) and an M10 Nylon Locknut (68).

24.Hold a Pulley (53) in the High Cable (54) as shown. Attach a Cable Trap (52) and the two Pulley Plates (17) to the Pulley using an M10 x 45mm Bolt (71) and an M10 Nylon Locknut (68).

Lay the Low Cable (55) over a Pulley (53) as shown. Attach the Pulley and a Cable Trap (52) to the Pulley Plates (17) using an M10 x 45mm Bolt

(71)and an M10 Nylon Locknut (68). Make sure the Bolts are inserted through the highest and lowest holes in the Pulley Plates. In addition, make sure the Cables are between the Cable Traps and the Pulleys.

22		53
76		54
	80	14
68
76		80
		76
80		73
		80
		76
23
	54

	55
	53
	76 79
		4
68		79
		76
	2	73
		71

2454

17

	53
68	52
	17

71

52

55

12