3. Attach the Frame (2) to the Crossbar (3) with two
M8 x 55mm Bolts (27), a Support Plate (28), and
two M8 Nylon Locknuts (13).
4. Tap three 38mm Square Inner Caps (21) into the
Leg Lever (4) as shown.
Insert the Weight Tube (30) into the indicated hole
in the Leg Lever (4). Press a 25mm Angle Cap
(20) onto the indicated end of the Weight Tube.
Press a 25mm Round Inner Cap (23) into the
other end of the Weight Tube (30).
5. Attach the Weight Tube (30) to the Leg Lever (4)
with an M8 x 50mm Bolt (17), two M8 Washers
(29), a 7mm Spacer (24), and an M8 Nylon
Locknut (13). Note: The 7mm Spacer will fit
tightly inside of the Leg Lever.
Lubricate the M10 x 60mm Bolt (18). Attach the
Leg Lever (4) to the Front Leg (8) with the Bolt
and an M10 Nylon Locknut (19). Do not overtight-
en the Nylon Locknut; the Leg Lever must be
able to pivot freely.
6. Tap two 19mm Round Inner Caps (9) into each
Pad Tube (10). Insert the Pad Tubes into the
holes in the Leg Lever (4). Slide two Foam Pads
(22) onto each Pad Tube.
7
3
27
28
2
3
13
21
21
21
4
23
20
30
4
4
19
Lubricate
8
18
24
29
13
30
17
29
5
22
10
9
9
10
22
9
22
4
9
22
6