SERVICE INSTRUCTIONS
FOR YOUR SAFETY
Service must be performed by a qualified service agency.
REPLACINGtTHE LIGHT BULBS
This fireplace uses 2 clear 110 Volt, 40 Watt,
WARNING: Do not exceed 40 Watts per bulb. Use of higher rated bulbs may result in a fire, causing property damage, personal injury or loss of life.
1.Turn off the power to the unit, and unplug it from the electrical outlet.
2.Let the fireplace cool if it has been operating.
3.Turn the fireplace so you are facing the back of the fireplace.
4.Look for the access plate with the gold printing on it.
5.Remove the 3 screws holding the access plate in position. Once you have removed the 3 screws, lift the access plate so the 2 positioning tabs come free of their slots. Once you have removed the access plate you can see and access the two 40 watt chandelier bulbs.
6.Remove each light bulb by unscrewing them out of the bases, turning them counterclockwise. You can use one hand to hold the light socket in place, if required.
7.Install the new light bulbs by turning each light bulb into the base clockwise. You can use one hand to hold the light socket in place, if required.
8.Replace the access plate by inserting the 2 tabs, pushing the plate up against the fireplace back, and inserting the 3 screws.
9.Turn the fireplace back so you are facing the front of the fireplace.
10.Plug the fireplace back into the electrical outlet and turn the power on and enjoy the flame effect.
SERVICE INSTRUCTIONS
Your fireplace has the following functions:
Leg Assembly:
Lay stove on a flat surface. Attach 4 legs with screws provided as shown in Fig. 1:
High heat | Low heat | On/Off |
1350 watts | 700 watts | Power to the uni |
|
| Fig. 1 |
Please note: Both the low heat and high heat
switches must be in the on position to achieve high heat.
