3.Carefully rotate the Console Base (45) to the posi- tion shown. Insert two Handrail Bolts (77) through the Console Base and the Upright (37). The

Handrail Bolts must be inserted from the inside as shown. Attach a Handrail Nut (86) and Handrail Washer (85) to each Handrail Bolt.

Tighten all four Handrail Bolts (77) as tightly as possible. Carefully lift up and push down on the handrails to make sure that the Console Base

(45)does not move. Regularly inspect and tight- en all four Handrail Bolts.

4.Attach the Frame Guide (66) to the left side of the Frame (21) with two Frame Guide Screws (44) as shown. Note: Be careful not to overtighten the Screws. Make sure that the thick end of the

Frame Guide is at the bottom.

5.Remove the backing from the Adhesive Clip (2). Press the Adhesive Clip onto the base of the Upright

(37)in the indicated location. Press the Allen Wrench (35) into the Adhesive Clip.

6.The Console (49) requires two "AA" batteries (not included); alkaline batteries are recommended.

Open the Battery Cover (48) as shown. Press two batteries into the battery compartment, with the nega- tive (Ð) ends of the batteries touching the springs. Close the battery cover, push up on the battery cover tab, and then push the tab forward as shown in the inset drawing. Be sure that the tab locks into place.

7.Make sure that all parts are properly tightened before you use the treadmill. The use of the remain- ing parts will be described in other sections of this manual. To protect the floor or carpet from dam- age, place a mat under the treadmill.

3

 

45

 

 

 

 

85

 

 

 

86

77

77

86

 

 

 

85

 

37

 

 

Handrails

45

 

77

 

77

 

 

 

37

 

 

4

 

 

 

66

 

 

 

44

 

 

 

 

 

21

 

Thick end

 

 

5

 

 

 

 

 

37

 

 

 

2

 

 

 

 

35

6

 

 

 

49

48

 

 

Batteries

 

 

Battery

 

 

Cover Tab

 

 

 

6

 

 

 

Page 6
Image 6
Weslo 925925 user manual Frame Guide is at the bottom