Weslo c42 user manual Assembly, Side View

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dis- pose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included small allen wrench			and your own phillips screwdriver		, rubber
mallet	, wire cutters	, adjustable wrenches		, and needlenose pliers	.

For help identifying the assembly hardware, refer to the PART IDENTIFICATION CHART in the center of this manual. Note: The assembly hardware and other small parts are packaged in separate part bags. Do not open the part bags until instructed to do so.

1.Make sure that the power cord is unplugged.

!

!

With the help of a second person, carefully tip the tread- mill onto its left side as shown. Partially fold the Frame

(75)so the treadmill is more stable. Do not fully fold the treadmill until it is completely assembled.

Open part bag A. Attach four Base Pads (40) to the Base (11) with two 1 1/4” Tek Screws (87) and two 3/4” Tek Screws (25). Attach a Wheel (37) to the right side of the Base with a Wheel Bolt (36) and a Wheel Nut (38).

2.See drawing 2a. Make sure that there are two U-nuts (97) in the lower end of each Upright (62, 76).

Identify the Right Upright (62), which has a large round hole and a slot near the lower end. While a second per- son holds the Right Upright near the Wire Harness (21), insert the end of the Wire Harness into the round hole and out of the upper end of the Right Upright.

1					40
		36			87
75	37
			40
	38	25
				40	87
	11		40
			25
2		2a		2b	47
		97
	76			62
			62, 76	Side View

Open part bag B. Slide the slot in the Right Upright (62) onto the Upright Lock Bracket (47) (see drawing 2b). Slide the Right Upright down until it reaches the Base (11). Make sure that the Wire Harness (21) is not pinched.

Handtighten two 2 1/2” Bolts (53) and two Star Washers

(9) into the Base and Right Upright.

With the help of a second person, tip the treadmill onto its other side. Attach the Left Upright (76) as described above. (Note: There is not a wire harness on the left side.) Attach the other Wheel (not shown) to the Base (11) as described in step 1.

62

Slot Round Hole

47

11

21

9

53

5