Weslo WCTL28090 user manual Assembly, Your own phillips screwdriver Scissors

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench

and your own phillips screwdriver and scissors .

1.Note that the Right Handrail (32) and the Console Base (not shown) are connected to the treadmill by the Wire Harness (53). During assembly steps 1 through 5, be careful to avoid pulling on or dam- aging the Wire Harness.

With the help of a second person, carefully lay the treadmill onto one side. Insert one of the Base Legs

(44)into the Upright (38) as shown. Make sure that the Base Leg Pad (33) is in the indicated position. Using the included Allen Wrench (81), attach the Base Leg with a Base Leg Screw (39). Attach the other Base Leg (44) in the same way.

With the help of a second person, carefully raise the treadmill to the upright position so that both Base Legs (44) are resting flat on the floor.

2.Carefully lower the treadmill. Remove the two indi- cated Latch Screws (8) and the shipping bracket from the left Upright (38). Save the Latch Screws for use in assembly step 3; discard the shipping bracket.

3.Remove the two remaining Latch Screws (8) from the left Upright (38).

Remove the cardboard and tape from the Latch (67). Attach the Latch to the left Upright (38) with the four Latch Screws (8). Make sure that the Latch

Screws are tight, but do not overtighten them; if the Latch Screws are overtightened, the Latch

(67)will not slide smoothly.

Note: The inset drawing shows how the parts of the Latch (67) fit together.

1
39	81
38
44
33
	53
44
33
39	32
2
	Shipping
	Bracket
8	38
3
38
8
67
	67

5