Weslo WCTL95335.0 user manual Screws before tightening them

5.Loosen the two (one shown) Crossbar Screws (98) sev- eral turns. Place the Console Base (87) on the Right Handrail (16) and the Left Handrail (not shown). Make sure that the Wire Harness is not pinched in the Right Handrail. Attach the Console Base with four 3/4” Screws (43) (only two Screws are shown). Start all four 3/4”

Screws before tightening them.

Insert the Wire Harness (53) through the two indicated plastic ties on the Console Base (87). Next, insert the Wire Harness up through the opening beside the Wire Cover (10). Make sure that the Wire Cover is securely at- tached to the Console Base.

See the inset drawing. Look at the top of the Console Base (87). Insert the Wire Harness (53) through the plas- tic tie on top of the Console Base.

6.Hold the Console (11) near the Console Base (87).

Touch the Right Handrail (16) to discharge any static. See the inset drawing. Find the 2-wire connector on the end of the Wire Harness (53). Insert the connector into the red connector beneath the Console. The connectors should slide together easily and snap into place. If they do not, turn the connector and then insert it. Insert the 6-wire connector into the socket beneath the Console the same way.

Insert the excess Wire Harness (53) down through the opening in the Console Base (87 [see the inset drawing in step 5]). Securely tighten the plastic tie on top of the Console Base to prevent the Wire Harness from slipping. Then, cut off the end of the plastic tie.

Make sure that the connectors and wires appear as shown at the right. IF THE CONNECTORS ARE NOT

INSERTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.

See drawing 6a. Press the Bookrack (85) onto the Console Base (87) in the location shown.

Set the Console (11) on the Console Base (87). Insert the excess Wire Harness (53) into the large hole in the side of the Right Handrail (16). Securely tighten the plastic ties on the bottom of the Console Base to prevent the Wire Harness from slipping. Then, cut off the ends of the plastic ties.

Attach the Console (11) to the Console Base (87) with two 3/4” Screws (43) and four 1/2” Screws (97). Start all six

Screws before tightening them; do not overtighten the Screws. Tighten the two Crossbar Screws (98) (only one is shown).

5		87
			53
				10
		Ties
43	98	16
			53		Tie
					87
6
		53	11
	Ties				87
		97	43
		98		43	97
		16		97
			53		6-wire
				2-wire
6a
			85
		87

8