Weslo WETL0254 Maintenance and Troubleshooting, Symptom the Console does not Function Properly

MAINTENANCE AND TROUBLESHOOTING

Most problems can be solved by following the simple steps below. If further assistance is needed, please call our Customer Service Department.

1.SYMPTOM: THE CONSOLE DOES NOT FUNCTION PROPERLY

a.Replace the batteries in the console (see assem- bly step 5 on page 5).

b.Make sure that the reed switch is properly adjust- ed (see assembly step 3 on page 4).

c.Make sure that the handrail wire is plugged fully into the wire on the console (see assembly step 6 on page 5).

d.The console, like most electronics, is susceptible to static electricity build-up caused by certain types of clothing or by the operation of the tread- mill. If the display is blank or gives incorrect read- ings, apply an anti-static spray to the handrail. Anti-static spray is available where laundry sup- plies are sold.

2.SYMPTOM: THE WALKING BELT DOES NOT MOVE SMOOTHLY

a. If the walk-
ing belt is
overtight-	Walking
ened, per-	Belt
formance
may be
reduced and
the walking
belt may be	5–7cm
permanently
damaged.	Bolts
Using the
hex key,

turn both rear roller adjustment bolts counter- clockwise 1/4 of a turn. When the tension of the walking belt is correct, you should be able to lift each side of the walking belt 5 to 7 cm (2 to 3 in.). Walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened. Be careful to keep the walking belt centred.

3.SYMPTOM: THE WALKING BELT SLIPS OR IS OFF-CENTRE

a. If the walking belt slips when walked

on, use the hex key to turn both adjust- ment bolts clockwise, 1/4

of a turn. When the walking belt is correctly tight- ened, you should be able to lift each side of the walking belt 5 to 7 cm (2 to 3 in.). Walk on the treadmill for a few minutes. Repeat until the walk- ing belt is properly tightened. Be careful to keep the walking belt centred.

b. If the walking belt has shift- ed to the left

side, use the hex key to turn the left adjust- ment bolt clockwise, and

the right adjustment bolt counterclockwise, 1/4 of a turn each. Be careful not to overtighten the walking belt. Walk on the treadmill for a few min- utes. Repeat until the walking belt is centred.

c. If the walking belt has shift- ed to the right

side, use the hex key to turn the left adjust- ment bolt coun- terclockwise,

and the right adjustment bolt clockwise, 1/4 of a turn each. Be careful not to overtighten the walk- ing belt. Walk on the treadmill for a few minutes. Repeat until the walking belt is centred.

8