Weslo WETL14905.1 user manual Screws and then tighten them, Top View

9.Securely tighten a plastic tie around the Wire Harness (60) and under the indicated hook on the Console (55) to prevent the Wire Harness from slipping. Tighten the plas- tic tie and cut off the end.

See drawing 9a. Set the Console (55) in the Console Base (52). Make sure that the Wire Harness (not shown) is not pinched. Next, set the Console Base on the Handrails (53, 59). Insert as much of the Wire Harness as possible into the hole in the Right Handrail (59). See step 7. Tighten the plastic tie and cut off the end.

Loosely thread six 3/4” Screws (2) into the Console Base

(52)and the Console (55). Loosely thread four 3/4”

Screws into the Handrails (only two Screws are shown).

Start all ten Screws and then tighten them; do not overtighten the Screws.

10.Lower the Handrails (53, 59) until they are touching the floor.

See 10a. Position the Handrails (53, 59) so the treadmill Frame (79) is centered between them.

Firmly tighten the four 2 1/2” Bolts (65), the two 2” Bolts (62), and the two 3 1/2” Bolts (70). Be careful not to overtighten the Bolts.

11.Orient the Latch Housing (48) so the large hole is on the indicated side. Attach the Latch Housing to the Left Handrail (53) with two 3/4” Screws (2); start both Latch

Screws and then tighten them.

Remove the knob from the pin. Make sure that the collar and the spring are on the pin. (Note: If there are two col- lars, place one on each side of the spring.) Next, insert the pin into the Latch Housing (48). Then, tighten the knob back onto the pin.

9	55
	Hook
	Tie
	60
9a	52	55
	2
59	2		2	53
10		70	65
		53, 59
				62
		65
		79
10a
		Top View
59		79		53
11
		2
	Knob	48

Spring

Collar

Pin 53

Large Hole

12.Make sure that all parts used in assembly are properly tightened before you use the treadmill. Keep the included hex key in a secure place; the hex key is used to adjust the walking belt (see page 17). To pro- tect the floor or carpet, place a mat under the treadmill.

9